[PATCH RESEND v3 0/5] I2C Mux per channel bus speed

[Marcus Folkesson]

On Tue, Dec 02, 2025 at 09:09:47AM +0100, Marcus Folkesson wrote:
> This was a RFC on how to implement a feature to have different bus
> speeds on different channels with an I2C multiplexer/switch.
> As no major complaints on the design came up during the review, I
> decided to submit the series without the RFC tag.
> 
> The benefit with this feature is that you may group devices after
> the fastest bus speed they can handle.
> A real-world example is that you could have e.g. a display running @400kHz
> and a smart battery running @100kHz using the same I2C controller.
> 
> There are many corner cases where this may cause a problem for some
> hardware topologies. I've tried to describe those I could think of
> in the documentation, see Patch #5.
> 
> E.g. one risk is that if the mux driver does not disconnect channels
> when Idle, this may cause a higher frequency to "leak" through to
> devices that are supposed to run at lower bus speed.
> This is not only a "problem" for changing bus speed but could also be
> an issue for potential address conflicts.
> 
> The implementation is split up into several patches:
> 
> Patch #1 Introduce a callback for the i2c controller to set bus speed
> Patch #2 Introduce functionality to adjust bus speed depending on mux
>          channel.
> Patch #3 Cleanup i2c-davinci driver a bit to prepare it for set_clk_freq
> Parch #4 Implement set_clk_freq for the i2c-davinci driver
> Parch #5 Update documentation with this feature
> 
> Signed-off-by: Marcus Folkesson <marcus.folkesson at gmail.com>

Ping on this series.

Best regards,
Marcus Folkesson
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 833 bytes
Desc: not available
URL: <http://lists.infradead.org/pipermail/linux-arm-kernel/attachments/20251228/ac532667/attachment-0001.sig>