[PATCH 2/2] dmaengine: xilinx: Simplify with scoped for each OF child loop

[Krzysztof Kozlowski]

Use scoped for-each loop when iterating over device nodes to make code a
bit simpler.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at oss.qualcomm.com>
---
 drivers/dma/xilinx/xilinx_dma.c | 8 +++-----
 1 file changed, 3 insertions(+), 5 deletions(-)

diff --git a/drivers/dma/xilinx/xilinx_dma.c b/drivers/dma/xilinx/xilinx_dma.c
index 89a8254d9cdc..21c8bff07dcf 100644
--- a/drivers/dma/xilinx/xilinx_dma.c
+++ b/drivers/dma/xilinx/xilinx_dma.c
@@ -3159,7 +3159,7 @@ static int xilinx_dma_probe(struct platform_device *pdev)
 					= axivdma_clk_init;
 	struct device_node *node = pdev->dev.of_node;
 	struct xilinx_dma_device *xdev;
-	struct device_node *child, *np = pdev->dev.of_node;
+	struct device_node *np = pdev->dev.of_node;
 	u32 num_frames, addr_width = XILINX_DMA_DFAULT_ADDRWIDTH, len_width;
 	int i, err;
 
@@ -3299,12 +3299,10 @@ static int xilinx_dma_probe(struct platform_device *pdev)
 	platform_set_drvdata(pdev, xdev);
 
 	/* Initialize the channels */
-	for_each_child_of_node(node, child) {
+	for_each_child_of_node_scoped(node, child) {
 		err = xilinx_dma_child_probe(xdev, child);
-		if (err < 0) {
-			of_node_put(child);
+		if (err < 0)
 			goto error;
-		}
 	}
 
 	if (xdev->dma_config->dmatype == XDMA_TYPE_VDMA) {
-- 
2.51.0