[PATCH 2/2] arm64: dts: imx94: add mt35xu512aba spi nor support

Haibo Chen haibo.chen at nxp.com
Tue Dec 23 01:05:57 PST 2025


Add mt35xu512aba spi nor support on imx943-evk board.
This nor chip support OCT DTR mode.

For the reset pin, since the nor chip side need 1.8v IO
voltage for reset pin, but the IO expander side use 3.3v
IO voltage, so to make circuit safe, need to config the
pad as OPEN DRAIN.

Signed-off-by: Haibo Chen <haibo.chen at nxp.com>
---
 arch/arm64/boot/dts/freescale/imx943-evk.dts | 34 ++++++++++++++++++++++++++++
 1 file changed, 34 insertions(+)

diff --git a/arch/arm64/boot/dts/freescale/imx943-evk.dts b/arch/arm64/boot/dts/freescale/imx943-evk.dts
index c8c3eff9df1a23c52e74bf2bc5d4ba543bb5a65b..19c02bd49cf5b0410b5d9f513ee279446ff79616 100644
--- a/arch/arm64/boot/dts/freescale/imx943-evk.dts
+++ b/arch/arm64/boot/dts/freescale/imx943-evk.dts
@@ -594,6 +594,22 @@ pinctrl_reg_usdhc2_vmmc: usdhc2regvmmcgrp {
 			IMX94_PAD_SD2_RESET_B__GPIO4_IO27	0x31e
 		>;
 	};
+
+	pinctrl_xspi1: xspi1grp {
+		fsl,pins = <
+			IMX94_PAD_XSPI1_SCLK__XSPI1_A_SCLK	0x3fe
+			IMX94_PAD_XSPI1_SS0_B__XSPI1_A_SS0_B	0x3fe
+			IMX94_PAD_XSPI1_DATA0__XSPI1_A_DATA0	0x3fe
+			IMX94_PAD_XSPI1_DATA1__XSPI1_A_DATA1	0x3fe
+			IMX94_PAD_XSPI1_DATA2__XSPI1_A_DATA2	0x3fe
+			IMX94_PAD_XSPI1_DATA3__XSPI1_A_DATA3	0x3fe
+			IMX94_PAD_XSPI1_DATA4__XSPI1_A_DATA4	0x3fe
+			IMX94_PAD_XSPI1_DATA5__XSPI1_A_DATA5	0x3fe
+			IMX94_PAD_XSPI1_DATA6__XSPI1_A_DATA6	0x3fe
+			IMX94_PAD_XSPI1_DATA7__XSPI1_A_DATA7	0x3fe
+			IMX94_PAD_XSPI1_DQS__XSPI1_A_DQS	0x3fe
+		>;
+	};
 };
 
 &usdhc1 {
@@ -625,3 +641,21 @@ &wdog3 {
 	fsl,ext-reset-output;
 	status = "okay";
 };
+
+&xspi1 {
+	pinctrl-0 = <&pinctrl_xspi1>;
+	pinctrl-1 = <&pinctrl_xspi1>;
+	pinctrl-names = "default", "sleep";
+	status = "okay";
+
+	mt35xu512aba: flash at 0 {
+		compatible = "jedec,spi-nor";
+		reg = <0>;
+		#address-cells = <1>;
+		#size-cells = <1>;
+		reset-gpios = <&pcal6416_i2c6_u50 15 (GPIO_ACTIVE_LOW | GPIO_OPEN_DRAIN)>;
+		spi-max-frequency = <200000000>;
+		spi-rx-bus-width = <8>;
+		spi-tx-bus-width = <8>;
+	};
+};

-- 
2.34.1




More information about the linux-arm-kernel mailing list