[PATCH v3 3/3] gpio: zynq: Simplify with device_get_match_data()

[Krzysztof Kozlowski]

Driver's probe function matches against driver's of_device_id table,
where each entry has non-NULL match data, so of_match_node() can be
simplified with device_get_match_data().

While changing the error message, switch to dev_err_probe() so error
path is a bit simpler.

Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at oss.qualcomm.com>
---
 drivers/gpio/gpio-zynq.c | 12 +++++-------
 1 file changed, 5 insertions(+), 7 deletions(-)

diff --git a/drivers/gpio/gpio-zynq.c b/drivers/gpio/gpio-zynq.c
index 97780c57ab56..571e366624d2 100644
--- a/drivers/gpio/gpio-zynq.c
+++ b/drivers/gpio/gpio-zynq.c
@@ -903,18 +903,16 @@ static int zynq_gpio_probe(struct platform_device *pdev)
 	struct zynq_gpio *gpio;
 	struct gpio_chip *chip;
 	struct gpio_irq_chip *girq;
-	const struct of_device_id *match;
 
 	gpio = devm_kzalloc(&pdev->dev, sizeof(*gpio), GFP_KERNEL);
 	if (!gpio)
 		return -ENOMEM;
 
-	match = of_match_node(zynq_gpio_of_match, pdev->dev.of_node);
-	if (!match) {
-		dev_err(&pdev->dev, "of_match_node() failed\n");
-		return -EINVAL;
-	}
-	gpio->p_data = match->data;
+	gpio->p_data = device_get_match_data(&pdev->dev);
+	if (!gpio->p_data)
+		return dev_err_probe(&pdev->dev, -EINVAL,
+				     "device_get_match_data() failed\n");
+
 	platform_set_drvdata(pdev, gpio);
 
 	gpio->base_addr = devm_platform_ioremap_resource(pdev, 0);

-- 
2.51.0