[PATCH v3 2/5] ARM: dts: aspeed: yosemite5: Remove ambiguous power monitor DTS nodes

[Kevin Tung]

Two different power monitor devices, using different drivers, reuse
I2C addresses 0x40 and 0x45 on bus 10 across Yosemite5 board variants.
Defining these devices statically in the DTS can lead to incorrect
driver binding on newer boards when the wrong device is instantiated.

Therefore, remove 10-0040 and 10-0045 device nodes, and let the driver
selection is instead handled in user space by the OpenBMC Entity
Manager based on the actual board configuration.

Signed-off-by: Kevin Tung <kevin.tung.openbmc at gmail.com>
---
 arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite5.dts | 14 --------------
 1 file changed, 14 deletions(-)

diff --git a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite5.dts b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite5.dts
index 7991e9360847532cff9aad4ad4ed57d4c30668a0..45b8ac2e8c65a4f672e64571631b7f6944f26213 100644
--- a/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite5.dts
+++ b/arch/arm/boot/dts/aspeed/aspeed-bmc-facebook-yosemite5.dts
@@ -674,20 +674,6 @@ gpio-expander at 22 {
 			"PWRGD_P3V3_AUX","ALERT_TEMP";
 	};
 
-	power-sensor at 40 {
-		compatible = "ti,ina233";
-		reg = <0x40>;
-		shunt-resistor = <2000>;
-		ti,maximum-expected-current-microamp = <32768000>;
-	};
-
-	power-sensor at 45 {
-		compatible = "ti,ina233";
-		reg = <0x45>;
-		shunt-resistor = <2000>;
-		ti,maximum-expected-current-microamp = <32768000>;
-	};
-
 	adc at 48 {
 		compatible = "ti,ads7830";
 		reg = <0x48>;

-- 
2.52.0