[PATCH v2] remoteproc: imx_dsp_rproc: only reset carveout memory at RPROC_OFFLINE state

[Frank Li]

On Thu, Dec 18, 2025 at 03:17:50PM +0800, Shengjiu Wang wrote:
> Do not reset memory at suspend and resume stage, because some
> memory is used to save the software state for resume, if it is cleared,
> the resume operation can fail.
>
> Fixes: c4c432dfb00f ("remoteproc: imx_dsp_rproc: Add support of recovery and coredump process")
> Signed-off-by: Shengjiu Wang <shengjiu.wang at nxp.com>
> Reviewed-by: Daniel Baluta <daniel.baluta at nxp.com>
> Reviewed-by: Iuliana Prodan <iuliana.prodan at nxp.com>
> ---
> changes in v2:
> - refine commit message.
Reviewed-by: Frank Li <Frank.Li at nxp.com>
>
>  drivers/remoteproc/imx_dsp_rproc.c | 8 +++++---
>  1 file changed, 5 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/remoteproc/imx_dsp_rproc.c b/drivers/remoteproc/imx_dsp_rproc.c
> index d03017d6b214..ac8aa71aa56c 100644
> --- a/drivers/remoteproc/imx_dsp_rproc.c
> +++ b/drivers/remoteproc/imx_dsp_rproc.c
> @@ -984,9 +984,11 @@ static int imx_dsp_rproc_load(struct rproc *rproc, const struct firmware *fw)
>  	 * Clear buffers after pm rumtime for internal ocram is not
>  	 * accessible if power and clock are not enabled.
>  	 */
> -	list_for_each_entry(carveout, &rproc->carveouts, node) {
> -		if (carveout->va)
> -			memset(carveout->va, 0, carveout->len);
> +	if (rproc->state == RPROC_OFFLINE) {
> +		list_for_each_entry(carveout, &rproc->carveouts, node) {
> +			if (carveout->va)
> +				memset(carveout->va, 0, carveout->len);
> +		}
>  	}
>
>  	ret = imx_dsp_rproc_elf_load_segments(rproc, fw);
> --
> 2.34.1
>