[RFC PATCH 11/38] arm_mpam: resctrl: Implement helpers to update configuration

[Jonathan Cameron]

On Fri, 5 Dec 2025 21:58:34 +0000
James Morse <james.morse at arm.com> wrote:

> resctrl has two helpers for updating the configuration.
> resctrl_arch_update_one() updates a single value, and is used by the
> software-controller to apply feedback to the bandwidth controls,
> it has to be called on one of the CPUs in the resctrl:domain.
> 
> resctrl_arch_update_domains() copies multiple staged configurations,
> it can be called from anywhere.
> 
> Both helpers should update any changes to the underlying hardware.
> 
> Imlpement resctrl_arch_update_domains() to use

Implement

> resctrl_arch_update_one(). Neither need to be called on a specific
> CPU as the mpam driver will send IPIs as needed.
> 
> Signed-off-by: James Morse <james.morse at arm.com>
> ---
>  drivers/resctrl/mpam_resctrl.c | 71 ++++++++++++++++++++++++++++++++++
>  1 file changed, 71 insertions(+)
> 
> diff --git a/drivers/resctrl/mpam_resctrl.c b/drivers/resctrl/mpam_resctrl.c
> index a26eb1f3efd0..ae0d17857b78 100644
> --- a/drivers/resctrl/mpam_resctrl.c
> +++ b/drivers/resctrl/mpam_resctrl.c

> +int resctrl_arch_update_domains(struct rdt_resource *r, u32 closid)
> +{
> +	int err = 0;
> +	enum resctrl_conf_type t;
> +	struct rdt_ctrl_domain *d;
> +	struct resctrl_staged_config *cfg;
> +
> +	lockdep_assert_cpus_held();
> +	lockdep_assert_irqs_enabled();
> +
> +	list_for_each_entry(d, &r->ctrl_domains, hdr.list) {
> +		for (t = 0; t < CDP_NUM_TYPES; t++) {
> +			cfg = &d->staged_config[t];
> +			if (!cfg->have_new_ctrl)
> +				continue;
> +
> +			err = resctrl_arch_update_one(r, d, closid, t,
> +						      cfg->new_ctrl);
> +			if (err)
> +				return err;
> +		}
> +	}
> +
> +	return err;

If it stays this simple in later patches
	return 0;

to make it clear this is the good path. Also can then avoid initializing
err at the top.


> +}
> +
>  void resctrl_arch_reset_all_ctrls(struct rdt_resource *r)
>  {
>  	struct mpam_resctrl_res *res;