[PATCH] remoteproc: imx_dsp_rproc: only reset carveout memory at RPROC_OFFLINE state

[Shengjiu Wang]

Don't need to reset memory at suspend and resume stage, because some
memory is used to save the software state for resume, if it is cleared,
the resume operation can fail.

Fixes: c4c432dfb00f ("remoteproc: imx_dsp_rproc: Add support of recovery and coredump process")
Signed-off-by: Shengjiu Wang <shengjiu.wang at nxp.com>
---
 drivers/remoteproc/imx_dsp_rproc.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/remoteproc/imx_dsp_rproc.c b/drivers/remoteproc/imx_dsp_rproc.c
index d03017d6b214..ac8aa71aa56c 100644
--- a/drivers/remoteproc/imx_dsp_rproc.c
+++ b/drivers/remoteproc/imx_dsp_rproc.c
@@ -984,9 +984,11 @@ static int imx_dsp_rproc_load(struct rproc *rproc, const struct firmware *fw)
 	 * Clear buffers after pm rumtime for internal ocram is not
 	 * accessible if power and clock are not enabled.
 	 */
-	list_for_each_entry(carveout, &rproc->carveouts, node) {
-		if (carveout->va)
-			memset(carveout->va, 0, carveout->len);
+	if (rproc->state == RPROC_OFFLINE) {
+		list_for_each_entry(carveout, &rproc->carveouts, node) {
+			if (carveout->va)
+				memset(carveout->va, 0, carveout->len);
+		}
 	}
 
 	ret = imx_dsp_rproc_elf_load_segments(rproc, fw);
-- 
2.34.1