[PATCH v1 10/17] firmware: arm_scmi: optee: Make use of module_tee_client_driver()

[Sumit Garg]

On Thu, Dec 11, 2025 at 06:15:04PM +0100, Uwe Kleine-König wrote:
> Reduce boilerplate by using the newly introduced module_tee_client_driver().
> That takes care of assigning the driver's bus, so the explicit assigning
> in this driver can be dropped.
> 
> Signed-off-by: Uwe Kleine-König <u.kleine-koenig at baylibre.com>
> ---
>  drivers/firmware/arm_scmi/transports/optee.c | 13 +------------
>  1 file changed, 1 insertion(+), 12 deletions(-)

Reviewed-by: Sumit Garg <sumit.garg at oss.qualcomm.com>

-Sumit

> 
> diff --git a/drivers/firmware/arm_scmi/transports/optee.c b/drivers/firmware/arm_scmi/transports/optee.c
> index dc0f46340153..8fdb80d3fabd 100644
> --- a/drivers/firmware/arm_scmi/transports/optee.c
> +++ b/drivers/firmware/arm_scmi/transports/optee.c
> @@ -612,23 +612,12 @@ static struct tee_client_driver scmi_optee_service_driver = {
>  	.id_table	= scmi_optee_service_id,
>  	.driver		= {
>  		.name = "scmi-optee",
> -		.bus = &tee_bus_type,
>  		.probe = scmi_optee_service_probe,
>  		.remove = scmi_optee_service_remove,
>  	},
>  };
>  
> -static int __init scmi_transport_optee_init(void)
> -{
> -	return driver_register(&scmi_optee_service_driver.driver);
> -}
> -module_init(scmi_transport_optee_init);
> -
> -static void __exit scmi_transport_optee_exit(void)
> -{
> -	driver_unregister(&scmi_optee_service_driver.driver);
> -}
> -module_exit(scmi_transport_optee_exit);
> +module_tee_client_driver(scmi_optee_service_driver);
>  
>  MODULE_AUTHOR("Etienne Carriere <etienne.carriere at foss.st.com>");
>  MODULE_DESCRIPTION("SCMI OPTEE Transport driver");
> -- 
> 2.47.3
>