[PATCH 05/19] coresight: trbe: Refactor status clearing

[Anshuman Khandual]

On 01/12/25 4:51 PM, Leo Yan wrote:
> If the driver does not clear the status when disabling the trace buffer
> unit, stale state will carry over to the next enable, though the driver
> clears it again on enable.

There is no problem now ! Because trbe_enable_hw() calls clr_trbe_status().

> 
> Explicitly clear status after the trace is disabled in the interrupt
> handling and when a perf session ends.  Keep the status for spurious
> interrupts for continuous tracing.

But is not that the behaviour already without this change ?

clr_trbe_status() in trbe_enable_hw() ensures that no TRBE session can be
started without first clearing the existing status. Still wondering what
is the purpose of this change ?

> 
> Signed-off-by: Leo Yan <leo.yan at arm.com>
> ---
>  drivers/hwtracing/coresight/coresight-trbe.c | 7 ++++++-
>  1 file changed, 6 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/hwtracing/coresight/coresight-trbe.c b/drivers/hwtracing/coresight/coresight-trbe.c
> index e426991e2c2c398a9d3982e9d0f7f542e404cbab..9e565122816949b37b8ff5e4ba04cfbc317c6f25 100644
> --- a/drivers/hwtracing/coresight/coresight-trbe.c
> +++ b/drivers/hwtracing/coresight/coresight-trbe.c
> @@ -629,7 +629,6 @@ static void trbe_enable_hw(struct trbe_buf *buf)
>  	WARN_ON(buf->trbe_hw_base < buf->trbe_base);
>  	WARN_ON(buf->trbe_write < buf->trbe_hw_base);
>  	WARN_ON(buf->trbe_write >= buf->trbe_limit);
> -	clr_trbe_status();
>  	set_trbe_base_pointer(buf->trbe_hw_base);
>  	set_trbe_write_pointer(buf->trbe_write);
>  
> @@ -1036,6 +1035,8 @@ static int arm_trbe_disable(struct coresight_device *csdev)
>  		return -EINVAL;
>  
>  	trbe_drain_and_disable_local(cpudata);
> +	clr_trbe_status();
> +
>  	buf->cpudata = NULL;
>  	cpudata->buf = NULL;
>  	cpudata->mode = CS_MODE_DISABLED;
> @@ -1151,6 +1152,10 @@ static irqreturn_t arm_trbe_irq_handler(int irq, void *dev)
>  		return IRQ_NONE;
>  
>  	act = trbe_get_fault_act(handle, status);
> +
> +	if (act != TRBE_FAULT_ACT_SPURIOUS)
> +		clr_trbe_status();
> +
>  	switch (act) {
>  	case TRBE_FAULT_ACT_WRAP:
>  		truncated = !!trbe_handle_overflow(handle);
>