[PATCH v2 10/11] clk: qcom: Add support for VideoCC driver for Kaanapali

[Taniya Das]

On 12/1/2025 6:45 PM, Konrad Dybcio wrote:
> On 11/25/25 6:45 PM, Taniya Das wrote:
>> Enable Kaanapali video clock driver for video SW to be able to control
>> the clocks from the Video SW driver.
>>
>> Signed-off-by: Taniya Das <taniya.das at oss.qualcomm.com>
>> ---
> 
> [...]
> 
>> +static struct clk_mem_branch video_cc_mvs0_freerun_clk = {
>> +	.mem_enable_reg = 0x80E4,
>> +	.mem_ack_reg =  0x80E4,
> 
> hex must be lowercase
> 

Sure, will fix this.

>> +	.mem_enable_mask = BIT(3),
>> +	.mem_enable_ack_mask = 0xc00,
> 
> GENMASK(11, 10)
> 

will fix this as well.

>> +	.mem_enable_invert = true,
>> +	.branch = {
>> +		.halt_reg = 0x80e0,
>> +		.halt_check = BRANCH_HALT,
>> +		.clkr = {
>> +			.enable_reg = 0x80e0,
>> +			.enable_mask = BIT(0),
>> +			.hw.init = &(const struct clk_init_data) {
>> +				.name = "video_cc_mvs0_freerun_clk",
>> +				.parent_hws = (const struct clk_hw*[]) {
>> +					&video_cc_mvs0_clk_src.clkr.hw,
>> +				},
>> +			.num_parents = 1,
>> +			.flags = CLK_SET_RATE_PARENT,
>> +			.ops = &clk_branch2_ops,
>> +			},
> 
> The indentation is a little malformed 
> 

will check this and fix.

> 
>> +static void clk_kaanapali_regs_configure(struct device *dev, struct regmap *regmap)
>> +{
>> +	/*
>> +	 * Enable clk_on sync for MVS0 and VPP clocks via VIDEO_CC_SPARE1
>> +	 * during core reset by default.
>> +	 */
>> +	regmap_update_bits(regmap, 0x9f24, BIT(0), BIT(0));
> 
> regmap_set_bits()
> 

Will replace with the new API.

> lgtm otherwise
> 
> Konrad

-- 
Thanks,
Taniya Das