[PATCH v20 3/7] firmware: imx: add driver for NXP EdgeLock Enclave

[Randy Dunlap]

Hi--

On 12/2/25 10:48 PM, Pankaj Gupta wrote:
> diff --git a/drivers/firmware/imx/Kconfig b/drivers/firmware/imx/Kconfig
> index 127ad752acf8..5fe96299b704 100644
> --- a/drivers/firmware/imx/Kconfig
> +++ b/drivers/firmware/imx/Kconfig
> @@ -55,3 +55,16 @@ config IMX_SCMI_MISC_DRV
>  	  core that could provide misc functions such as board control.
>  
>  	  This driver can also be built as a module.
> +
> +config IMX_SEC_ENCLAVE
> +	tristate "i.MX Embedded Secure Enclave - EdgeLock Enclave Firmware driver."
> +	depends on IMX_MBOX && ARCH_MXC && ARM64

Is it possible to work COMPILE_TEST into this dependency?

> +	select FW_LOADER
> +	default m if ARCH_MXC
> +
> +	help
> +	  Exposes APIs supported by the iMX Secure Enclave HW IP called:
> +	  - EdgeLock Enclave Firmware (for i.MX8ULP, i.MX93),
> +	    like base, HSM, V2X & SHE using the SAB protocol via the shared Messaging
> +	    Unit. This driver exposes these interfaces via a set of file descriptors
> +	    allowing to configure shared memory, send and receive messages.

thanks.
-- 
~Randy