[PATCH] arm64: dts: allwinner: a527: cubie-a5e: Add LEDs

[Chen-Yu Tsai]

From: Chen-Yu Tsai <wens at csie.org>

The Radxa Cubie A5E has a 3-color LED. The green and blue LEDs are wired
to GPIO pins on the SoC, and the green one is lit by default to serve as
a power indicator. The red LED is wired to the M.2 slot.

Add device nodes for the green and blue LEDs.

A default "heartbeat" trigger is set for the green power LED, though in
practice it might be better if it were inverted, i.e. lit most of the
time.

Signed-off-by: Chen-Yu Tsai <wens at csie.org>
---
 .../dts/allwinner/sun55i-a527-cubie-a5e.dts   | 19 +++++++++++++++++++
 1 file changed, 19 insertions(+)

diff --git a/arch/arm64/boot/dts/allwinner/sun55i-a527-cubie-a5e.dts b/arch/arm64/boot/dts/allwinner/sun55i-a527-cubie-a5e.dts
index fce2b7d1ba3d..cb2a2b62a2b2 100644
--- a/arch/arm64/boot/dts/allwinner/sun55i-a527-cubie-a5e.dts
+++ b/arch/arm64/boot/dts/allwinner/sun55i-a527-cubie-a5e.dts
@@ -6,6 +6,7 @@
 #include "sun55i-a523.dtsi"
 
 #include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/leds/common.h>
 
 / {
 	model = "Radxa Cubie A5E";
@@ -28,6 +29,24 @@ ext_osc32k: ext-osc32k-clk {
 		clock-output-names = "ext_osc32k";
 	};
 
+	leds {
+		compatible = "gpio-leds";
+
+		power-led {
+			function = LED_FUNCTION_POWER;
+			color = <LED_COLOR_ID_GREEN>;
+			gpios = <&r_pio 0 4 GPIO_ACTIVE_LOW>; /* PL4 */
+			default-state = "on";
+			linux,default-trigger = "heartbeat";
+		};
+
+		use-led {
+			function = LED_FUNCTION_ACTIVITY;
+			color = <LED_COLOR_ID_BLUE>;
+			gpios = <&r_pio 0 5 GPIO_ACTIVE_LOW>; /* PL5 */
+		};
+	};
+
 	reg_vcc5v: vcc5v {
 		/* board wide 5V supply from the USB-C connector */
 		compatible = "regulator-fixed";
-- 
2.39.5