[PATCH v5 0/8] Support Multi-frequency scale for UFS

[Ziqi Chen]

Hi Luca,

Thanks for your report.
Really,  6350 is a special platform that the UFS_PHY_AXI_CLK doesn't
match to the UFS_PHY_UNIPRO_CORE_CLK. We already found out the root
cause and discussing the fix. We will submit change to fix this corner
case.

BRs
Ziqi

On 4/26/2025 3:48 AM, Luca Weiss wrote:
> Hi Ziqi,
> 
> On Thu Feb 13, 2025 at 9:00 AM CET, Ziqi Chen wrote:
>> With OPP V2 enabled, devfreq can scale clocks amongst multiple frequency
>> plans. However, the gear speed is only toggled between min and max during
>> clock scaling. Enable multi-level gear scaling by mapping clock frequencies
>> to gear speeds, so that when devfreq scales clock frequencies we can put
>> the UFS link at the appropraite gear speeds accordingly.
> 
> I believe this series is causing issues on SM6350:
> 
> [    0.859449] ufshcd-qcom 1d84000.ufshc: ufs_qcom_freq_to_gear_speed: Unsupported clock freq : 200000000
> [    0.886668] ufshcd-qcom 1d84000.ufshc: UNIPRO clk freq 200 MHz not supported
> [    0.903791] devfreq 1d84000.ufshc: dvfs failed with (-22) error
> 
> That's with this patch, I actually haven't tried without on v6.15-rc3
> https://lore.kernel.org/all/20250314-sm6350-ufs-things-v1-2-3600362cc52c@fairphone.com/
> 
> I believe the issue appears because core clk and unipro clk rates don't
> match on this platform, so this 200 MHz for GCC_UFS_PHY_AXI_CLK is not a
> valid unipro clock rate, but for GCC_UFS_PHY_UNIPRO_CORE_CLK it's
> specified to 150 MHz in the opp table.
> 
> Regards
> Luca
> 
>>
>> This series has been tested on below platforms -
>> sm8550 mtp + UFS3.1
>> SM8650 MTP + UFS3.1
>> SM8750 MTP + UFS4.0