[PATCH 3/3] pinctrl: bcm2835: use new GPIO line value setter callbacks

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

struct gpio_chip now has callbacks for setting line values that return
an integer, allowing to indicate failures. Convert the driver to using
them.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/pinctrl/bcm/pinctrl-bcm2835.c | 9 ++++++---
 1 file changed, 6 insertions(+), 3 deletions(-)

diff --git a/drivers/pinctrl/bcm/pinctrl-bcm2835.c b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
index eaeec096bc9a..826827800474 100644
--- a/drivers/pinctrl/bcm/pinctrl-bcm2835.c
+++ b/drivers/pinctrl/bcm/pinctrl-bcm2835.c
@@ -356,11 +356,14 @@ static int bcm2835_gpio_get_direction(struct gpio_chip *chip, unsigned int offse
 	return GPIO_LINE_DIRECTION_IN;
 }
 
-static void bcm2835_gpio_set(struct gpio_chip *chip, unsigned offset, int value)
+static int bcm2835_gpio_set(struct gpio_chip *chip, unsigned int offset,
+			    int value)
 {
 	struct bcm2835_pinctrl *pc = gpiochip_get_data(chip);
 
 	bcm2835_gpio_set_bit(pc, value ? GPSET0 : GPCLR0, offset);
+
+	return 0;
 }
 
 static int bcm2835_gpio_direction_output(struct gpio_chip *chip,
@@ -394,7 +397,7 @@ static const struct gpio_chip bcm2835_gpio_chip = {
 	.direction_output = bcm2835_gpio_direction_output,
 	.get_direction = bcm2835_gpio_get_direction,
 	.get = bcm2835_gpio_get,
-	.set = bcm2835_gpio_set,
+	.set_rv = bcm2835_gpio_set,
 	.set_config = gpiochip_generic_config,
 	.base = -1,
 	.ngpio = BCM2835_NUM_GPIOS,
@@ -411,7 +414,7 @@ static const struct gpio_chip bcm2711_gpio_chip = {
 	.direction_output = bcm2835_gpio_direction_output,
 	.get_direction = bcm2835_gpio_get_direction,
 	.get = bcm2835_gpio_get,
-	.set = bcm2835_gpio_set,
+	.set_rv = bcm2835_gpio_set,
 	.set_config = gpiochip_generic_config,
 	.base = -1,
 	.ngpio = BCM2711_NUM_GPIOS,

-- 
2.45.2