[PATCH 4/5] arm64: dts: allwinner: a527: add EMAC0 to Radxa A5E board

[Andrew Lunn]

On Thu, Apr 24, 2025 at 01:42:41AM +0100, Andre Przywara wrote:
> On Wed, 23 Apr 2025 18:58:37 +0200
> Andrew Lunn <andrew at lunn.ch> wrote:
> 
> Hi,
> 
> > > +&emac0 {
> > > +	phy-mode = "rgmii";  
> > 
> > Does the PCB have extra long clock lines in order to provide the
> > needed 2ns delay? I guess not, so this should be rgmii-id.
> 
> That's a good point, and it probably true.
> 
> > 
> > > +	phy-handle = <&ext_rgmii_phy>;
> > > +
> > > +	allwinner,tx-delay-ps = <300>;
> > > +	allwinner,rx-delay-ps = <400>;  
> > 
> > These are rather low delays, since the standard requires 2ns. Anyway,
> > once you change phy-mode, you probably don't need these.
> 
> Those go on top of the main 2ns delay

Which 2ns delay? "rgmii" means don't add 2ns delay, the PCB is doing
it. So if there is a 2ns delay, something is broken by not respecting
"rgmii".

> I just tried, it also works with some variations of those values, but
> setting tx-delay to 0 stops communication.

Just to be clear, you tried it with "rgmii-id" and the same <300> and
<400> values?

	Andrew