[PATCH 06/12] pinctrl: ingenic: use new GPIO line value setter callbacks

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

struct gpio_chip now has callbacks for setting line values that return
an integer, allowing to indicate failures. Convert the driver to using
them.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/pinctrl/pinctrl-ingenic.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/pinctrl/pinctrl-ingenic.c b/drivers/pinctrl/pinctrl-ingenic.c
index a9e48eac15f6..3c660471ec69 100644
--- a/drivers/pinctrl/pinctrl-ingenic.c
+++ b/drivers/pinctrl/pinctrl-ingenic.c
@@ -3800,12 +3800,14 @@ static void ingenic_gpio_irq_handler(struct irq_desc *desc)
 	chained_irq_exit(irq_chip, desc);
 }
 
-static void ingenic_gpio_set(struct gpio_chip *gc,
-		unsigned int offset, int value)
+static int ingenic_gpio_set(struct gpio_chip *gc, unsigned int offset,
+			    int value)
 {
 	struct ingenic_gpio_chip *jzgc = gpiochip_get_data(gc);
 
 	ingenic_gpio_set_value(jzgc, offset, value);
+
+	return 0;
 }
 
 static int ingenic_gpio_get(struct gpio_chip *gc, unsigned int offset)
@@ -4449,7 +4451,7 @@ static int __init ingenic_gpio_probe(struct ingenic_pinctrl *jzpc,
 	jzgc->gc.fwnode = fwnode;
 	jzgc->gc.owner = THIS_MODULE;
 
-	jzgc->gc.set = ingenic_gpio_set;
+	jzgc->gc.set_rv = ingenic_gpio_set;
 	jzgc->gc.get = ingenic_gpio_get;
 	jzgc->gc.direction_input = pinctrl_gpio_direction_input;
 	jzgc->gc.direction_output = ingenic_gpio_direction_output;

-- 
2.45.2