[PATCH 06/12] gpio: janz-ttl: use new line value setter callbacks

[Bartosz Golaszewski]

From: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>

struct gpio_chip now has callbacks for setting line values that return
an integer, allowing to indicate failures. Convert the driver to using
them.

Signed-off-by: Bartosz Golaszewski <bartosz.golaszewski at linaro.org>
---
 drivers/gpio/gpio-janz-ttl.c | 6 ++++--
 1 file changed, 4 insertions(+), 2 deletions(-)

diff --git a/drivers/gpio/gpio-janz-ttl.c b/drivers/gpio/gpio-janz-ttl.c
index cdf50e4ea165..9f548eda3888 100644
--- a/drivers/gpio/gpio-janz-ttl.c
+++ b/drivers/gpio/gpio-janz-ttl.c
@@ -76,7 +76,7 @@ static int ttl_get_value(struct gpio_chip *gpio, unsigned offset)
 	return !!ret;
 }
 
-static void ttl_set_value(struct gpio_chip *gpio, unsigned offset, int value)
+static int ttl_set_value(struct gpio_chip *gpio, unsigned int offset, int value)
 {
 	struct ttl_module *mod = dev_get_drvdata(gpio->parent);
 	void __iomem *port;
@@ -103,6 +103,8 @@ static void ttl_set_value(struct gpio_chip *gpio, unsigned offset, int value)
 
 	iowrite16be(*shadow, port);
 	spin_unlock(&mod->lock);
+
+	return 0;
 }
 
 static void ttl_write_reg(struct ttl_module *mod, u8 reg, u16 val)
@@ -169,7 +171,7 @@ static int ttl_probe(struct platform_device *pdev)
 	gpio->parent = &pdev->dev;
 	gpio->label = pdev->name;
 	gpio->get = ttl_get_value;
-	gpio->set = ttl_set_value;
+	gpio->set_rv = ttl_set_value;
 	gpio->owner = THIS_MODULE;
 
 	/* request dynamic allocation */

-- 
2.45.2