[RFC] arm64: dts: allwinner: a64: Add overlay for Realtek

[Dragan Simic]

Hello Peter,

On 2025-04-19 18:07, Peter Robinson wrote:
> Add overlay for the Pine64 Realtek rtl8723bs WiFi
> module that works on the Pine64/64+/SoPine devices.
> 
> Signed-off-by: Peter Robinson <pbrobinson at gmail.com>
> 
> I've looked at overlays for other vendors, such as available
> for some of the Rockchip devices, and I believe I have this
> mostly correct but would like some feedback both on if I have
> everything needed for Allwinner devices, but also what's needed
> to be able to use a single overlay across more than one device.
> 
> This is dependent on the following [1] patch series.
> 
> Peter
> 
> [1] 
> https://lore.kernel.org/linux-devicetree/20250419160051.677485-3-pbrobinson@gmail.com/t/#u
> 
> ---
>  arch/arm64/boot/dts/allwinner/Makefile        |  6 ++++
>  .../allwinner/sun50i-a64-pine64-realtek.dtso  | 30 +++++++++++++++++++
>  2 files changed, 36 insertions(+)
>  create mode 100644 
> arch/arm64/boot/dts/allwinner/sun50i-a64-pine64-realtek.dtso
> 
> diff --git a/arch/arm64/boot/dts/allwinner/Makefile
> b/arch/arm64/boot/dts/allwinner/Makefile
> index 00bed412ee31..be991f8d8110 100644
> --- a/arch/arm64/boot/dts/allwinner/Makefile
> +++ b/arch/arm64/boot/dts/allwinner/Makefile
> @@ -8,6 +8,7 @@ dtb-$(CONFIG_ARCH_SUNXI) += 
> sun50i-a64-olinuxino-emmc.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-orangepi-win.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-pine64-lts.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-pine64-plus.dtb 
> sun50i-a64-pine64.dtb
> +dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-pine64-realtek.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-pinebook.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-pinephone-1.0.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-a64-pinephone-1.1.dtb
> @@ -52,3 +53,8 @@ dtb-$(CONFIG_ARCH_SUNXI) +=
> sun50i-h700-anbernic-rg35xx-2024.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h700-anbernic-rg35xx-h.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h700-anbernic-rg35xx-plus.dtb
>  dtb-$(CONFIG_ARCH_SUNXI) += sun50i-h700-anbernic-rg35xx-sp.dtb
> +
> +# Overlays
> +sun50i-a64-pine64-realtek-dtbs      := sun50i-a64-pine64.dtb
> sun50i-a64-pine64-realtek.dtbo
> +sun50i-a64-pine64-lts-realtek-dtbs  := sun50i-a64-pine64-lts.dtb
> sun50i-a64-pine64-realtek.dtbo
> +sun50i-a64-pine64-plus-realtek-dtbs := sun50i-a64-pine64-plus.dtb
> sun50i-a64-pine64-realtek.dtbo

Thanks for the patch, having this DT overlay makes perfectly
sense to me.  The only possible issues may arise from the
resulting size increase of the compiled .dtb files, caused by
the implicit inclusion of symbols.

However, please see an earlier linux-rockchip thread [2] that
shows the desired layout of the additions to the Makefile, which
was determined through a few rounds of discussion.

Finally, I think we should choose a slightly better name for the
DT overlay, instead of "sun50i-a64-pine64-realtek.dtso", in which
"-realtek" seems a bit to vague.  Perhaps "-wifi-bt-addon" as the
filename suffix would fit better, and it's virtually guaranteed
that there will be no new version of that add-on board, so there
should be no potential for name clashing.

As a minor suggestion, the patch subject should also be tweaked
a bit, because "Realtek" is also a bit too vague there.

[2] 
https://lore.kernel.org/linux-rockchip/20250226140942.3825223-4-heiko@sntech.de/

> diff --git
> a/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64-realtek.dtso
> b/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64-realtek.dtso
> new file mode 100644
> index 000000000000..51b57a46e23f
> --- /dev/null
> +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64-realtek.dtso
> @@ -0,0 +1,30 @@
> +// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
> +// Copyright (c) 2025 Peter Robinson
> +
> +/dts-v1/;
> +/plugin/;
> +
> +#include <dt-bindings/gpio/gpio.h>
> +#include <dt-bindings/interrupt-controller/arm-gic.h>
> +
> +&mmc1 {
> +	status = "okay";
> +
> +	rtl8723bs: wifi at 1 {
> +		reg = <1>;
> +		interrupt-parent = <&r_pio>;
> +		interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>; /* PL3 */
> +		interrupt-names = "host-wake";
> +	};
> +};
> +
> +&uart1 {
> +	status = "okay";
> +
> +	bluetooth {
> +		compatible = "realtek,rtl8723bs-bt";
> +		device-wake-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /* PL6 */
> +		enable-gpios = <&r_pio 0 4 GPIO_ACTIVE_HIGH>; /* PL4 */
> +		host-wake-gpios = <&r_pio 0 5 GPIO_ACTIVE_HIGH>; /* PL5 */
> +	};
> +};