[PATCH v1 2/2] arm64: dts: qcom: sa8775p: Add support for camss

[Konrad Dybcio]

On 4/18/25 9:28 AM, Vikram Sharma wrote:
> 
> On 4/14/2025 7:18 PM, Konrad Dybcio wrote:
>> On 2/10/25 4:56 PM, Vikram Sharma wrote:
>>> Add changes to support the camera subsystem on the SA8775P.
>>>
>>> Co-developed-by: Suresh Vankadara <quic_svankada at quicinc.com>
>>> Signed-off-by: Suresh Vankadara <quic_svankada at quicinc.com>
>>> Signed-off-by: Vikram Sharma <quic_vikramsa at quicinc.com>
>>> ---
>> [...]
>>
>>> +            interrupts = <GIC_SPI 565 IRQ_TYPE_EDGE_RISING>,
>>> +                     <GIC_SPI 564 IRQ_TYPE_EDGE_RISING>,
>>> +                     <GIC_SPI 468 IRQ_TYPE_EDGE_RISING>,
>>> +                     <GIC_SPI 359 IRQ_TYPE_EDGE_RISING>,
>>> +                     <GIC_SPI 759 IRQ_TYPE_EDGE_RISING>,
>> 760> +                     <GIC_SPI 758 IRQ_TYPE_EDGE_RISING>,
> 
> Hi Konrad,
> 
> We cross checked internal documents to confirm IRQ number for csid_lite2/3 and vfe_lite2/3
> Calculation for IRQ number is done with respect to vector number as
> irq_num = (vector - 32).
> csid_lite2 vector -> 791
> csid_lite3 vector -> 790
> vfe_lite2  vector -> 793
> vfe_lite3  vector -> 792
> 
> thus irqs are as
> csid_lite2 -> 759
> csid_lite3 -> 758
> vfe_lite2  -> 761
> vfe_lite3  -> 760
> 
> Please let me know if this looks fine to you?

We had a similar issue with qcs8300 - the reported vector id skipped a
number at some point. In that case the SPI ports indices alongside
them were advised to be used. Please check with the HW team, but I
suppose this would be the case for this one too.

Konrad