[net-next v4 5/5] ARM: mxs_defconfig: Enable CONFIG_FEC_MTIP_L2SW to support MTIP L2 switch

[Stefan Wahren]

Hi Lukasz,

Am 07.04.25 um 16:51 schrieb Lukasz Majewski:
> This patch enables support for More Than IP switch available on some
> imx28[7] devices.
>
> Signed-off-by: Lukasz Majewski <lukma at denx.de>
thanks adding the driver to mxs_defconfig. Unfortunately it's not
possible for reviewers to identify the relevant changes, also the commit
messages doesn't provide further information.

In general there are two approaches to solves this:
1) prepend an additional patch which synchronizes mxs_defconfig with
current mainline
2) manually create the relevant changes against mxs_defconfig

The decision about the approaches is up to the maintainer.

Btw driver review will follow ...

Regards
> ---
> Changes for v4:
> - New patch
> ---
>   arch/arm/configs/mxs_defconfig | 14 +++-----------
>   1 file changed, 3 insertions(+), 11 deletions(-)
>
> diff --git a/arch/arm/configs/mxs_defconfig b/arch/arm/configs/mxs_defconfig
> index d8a6e43c401e..4dc4306c035f 100644
> --- a/arch/arm/configs/mxs_defconfig
> +++ b/arch/arm/configs/mxs_defconfig
> @@ -32,11 +32,10 @@ CONFIG_INET=y
>   CONFIG_IP_PNP=y
>   CONFIG_IP_PNP_DHCP=y
>   CONFIG_SYN_COOKIES=y
> -# CONFIG_INET_XFRM_MODE_TRANSPORT is not set
> -# CONFIG_INET_XFRM_MODE_TUNNEL is not set
> -# CONFIG_INET_XFRM_MODE_BEET is not set
>   # CONFIG_INET_DIAG is not set
>   # CONFIG_IPV6 is not set
> +CONFIG_BRIDGE=y
> +CONFIG_NET_SWITCHDEV=y
>   CONFIG_CAN=m
>   # CONFIG_WIRELESS is not set
>   CONFIG_DEVTMPFS=y
> @@ -45,7 +44,6 @@ CONFIG_MTD=y
>   CONFIG_MTD_CMDLINE_PARTS=y
>   CONFIG_MTD_BLOCK=y
>   CONFIG_MTD_DATAFLASH=y
> -CONFIG_MTD_M25P80=y
>   CONFIG_MTD_SST25L=y
>   CONFIG_MTD_RAW_NAND=y
>   CONFIG_MTD_NAND_GPMI_NAND=y
> @@ -56,11 +54,11 @@ CONFIG_EEPROM_AT24=y
>   CONFIG_SCSI=y
>   CONFIG_BLK_DEV_SD=y
>   CONFIG_NETDEVICES=y
> +CONFIG_FEC_MTIP_L2SW=y
>   CONFIG_ENC28J60=y
>   CONFIG_ICPLUS_PHY=y
>   CONFIG_MICREL_PHY=y
>   CONFIG_REALTEK_PHY=y
> -CONFIG_SMSC_PHY=y
>   CONFIG_CAN_FLEXCAN=m
>   CONFIG_USB_USBNET=y
>   CONFIG_USB_NET_SMSC95XX=y
> @@ -77,13 +75,11 @@ CONFIG_SERIAL_AMBA_PL011=y
>   CONFIG_SERIAL_AMBA_PL011_CONSOLE=y
>   CONFIG_SERIAL_MXS_AUART=y
>   # CONFIG_HW_RANDOM is not set
> -# CONFIG_I2C_COMPAT is not set
>   CONFIG_I2C_CHARDEV=y
>   CONFIG_I2C_MXS=y
>   CONFIG_SPI=y
>   CONFIG_SPI_GPIO=m
>   CONFIG_SPI_MXS=y
> -CONFIG_GPIO_SYSFS=y
>   # CONFIG_HWMON is not set
>   CONFIG_WATCHDOG=y
>   CONFIG_STMP3XXX_RTC_WATCHDOG=y
> @@ -138,10 +134,6 @@ CONFIG_PWM_MXS=y
>   CONFIG_NVMEM_MXS_OCOTP=y
>   CONFIG_EXT4_FS=y
>   # CONFIG_DNOTIFY is not set
> -CONFIG_NETFS_SUPPORT=m
> -CONFIG_FSCACHE=y
> -CONFIG_FSCACHE_STATS=y
> -CONFIG_CACHEFILES=m
>   CONFIG_VFAT_FS=y
>   CONFIG_TMPFS=y
>   CONFIG_TMPFS_POSIX_ACL=y