[PATCH v2 0/3] Add the dwmac driver support for T-HEAD TH1520 SoC

[Andrew Lunn]

> Regarding rx and tx internal delays, that same section in the manual
> doesn't specify what unit is represented by the delay_ctrl bit field in
> GMAC_RXCLK_DELAY_CTRL and GMAC_TXCLK_DELAY_CTRL. It is only 5 bits and
> a max value of 31 seems too small to represent picoseconds. The vendor
> kernel [2] uses properties named "rx-clk-delay" and "tx-clk-delay" but
> doesn't indicate any units. I see ti,dp83867.yaml adds vendor specific
> rx and tx delay properties so that is what I've now done in this series.
> Note: the hardware default value of 0 for delay_ctrl works okay for the
> TH1520 hardware that I have.

I assume you are talking about RGMII delays here?

Do you have a board which needs to set these delays? In general, linux
has the PHY provide the 2ns delay. You only need the MAC to add the
delays if a PHY is being used which cannot add the needed
delays. Occasionally you need to fine tune the delay, and the MAC
delays can then be interesting. But since you have no idea what the
units are, i would prefer to simply hard code it to 0, unless is it
really needed.

	Andrew