[PATCH 2/2] arm64: dts: imx8mp: Add DH i.MX8MP DHCOM SoM on DRC02 carrier board

[Frank Li]

On Wed, Sep 25, 2024 at 11:09:13PM +0200, Marek Vasut wrote:
> On 9/25/24 6:30 PM, Frank Li wrote:
>
> [...]
>
> > > +/* USB_OTG port is not routed out on DRC02. */
> > > +&usb3_0 {
> > > +	status = "disabled";
> > > +};
> > > +
> > > +&usb_dwc3_0 {
> > > +	status = "disabled";
> > > +};
> > > +
> > > +/* USB_HOST port has USB Hub connected to it, PWR/OC pins are unused */
> > > +&usb3_1 {
> > > +	fsl,disable-port-power-control;
> > > +	fsl,permanently-attached;
> > > +};
> >
> > Suggest run https://github.com/lznuaa/dt-format to sort node
> >
> > &usb_dwc3_0
> > &usb_dwc3_1
> > &usb3_0
> > &usb3_1
>
> I'm afraid the tool (I did not try it, I used plain GNU sort) is not sorting
> this correctly, look at ASCII table, 0x33 is '3' and 0x5f is '_':
>
> $ printf 3_ | hexdump -vC
> 00000000  33 5f

Sorry, I have not run it for this dts. I make misstake - and _ at ascii
table.

>
> So if the sorting was correct, it would be:
>
> usb3_0
> usb3_1
> usb_dwc3_0
> usb_dwc3_1
>
> But I would prefer to keep the controllers close to each other, i.e. the
> current order which seems more logical in this case:
>
> usb3_0
> usb_dwc3_0
> usb3_1
> usb_dwc3_1

next time, we should use better label name in chip.dtsi file. I try to
reduce trivial node name order issue in patch review. And make contributor
to be easy to follow.

Frank

>
> [...]