[PATCH 0/8] Add generic overlay for MikroBUS addon boards

[Alexander Stein]

Hi,

Am Mittwoch, 11. September 2024, 16:27:17 CEST schrieb Ayush Singh:
> Hello all,
> 
> This is an attempt to add MikroBUS addon support using the approach
> described by Grove connector patch series [0].
> 
> The patch series tests out 2 addon boards + pwm and GPIO on the MikroBUS
> connector. The boards used are GPS3 Click (for UART) [1] and Weather
> Click (for I2C) [2]. Additionally, I have tested relative GPIO numbering
> using devicetree nexus nodes [3].
> 
> The patch series does not attempt to do any dynamic discovery for 1-wire
> eeprom MikroBUS addon boards, nor does it provide any sysfs entry for
> board addition/removal. The connector driver might include them after
> the basic support is ironed out, but the existing patches for dynamic
> overlays work fine.
> [sniip]

To put it in a more abstract perspective, aren't you "just" defining some
kind of connector with a fixed layout of pins and features?
It's not really different to Arduino Shields and Raspberry Pi hats, no?
Ignoring multi-purpose pins for GPIO or e.g. I2C, this is about matching
the plugin module's pins to platform-specific on-board peripherals.

Sticking the name to MikroBUS might be misleading, because this is AFAICT
just a trademark for a specific connector pin layout.
This concept could be applied for any kind of connector, where e.g.
the I2C interface is mapped to i2c0 on one platform and to lpi2c5
on a different platform.

Best regards,
Alexander
-- 
TQ-Systems GmbH | Mühlstraße 2, Gut Delling | 82229 Seefeld, Germany
Amtsgericht München, HRB 105018
Geschäftsführer: Detlef Schneider, Rüdiger Stahl, Stefan Schneider
http://www.tq-group.com/