[PATCH 3/3] arm64: dts: allwinner: a64: Add WiFi/BT on Pine64

[Andre Przywara]

Hi,

On 03/09/2024 06:50, Icenowy Zheng wrote:
> 在 2024-09-01星期日的 13:21 +0100，Peter Robinson写道：
>> Enable the rtl8723bs WiFi/BT modules on the Pine64.
> 
> I think the maintainer previously prefer to enable these modules with
> DT overlays.

Yes, we cannot have this enabled unconditionally, especially since this 
is explicitly given as the reason for the first two patches.
So either this would just stay on the list, for reference, (maybe marked 
as DON'T MERGE), or, better: we indeed rewrite this as an overlay.

I will give the series a test once I am back with my beloved boards.

Cheers,
Andre

> 
>>
>> Signed-off-by: Peter Robinson <pbrobinson at gmail.com>
>> ---
>>   .../boot/dts/allwinner/sun50i-a64-pine64.dts    | 17
>> ++++++++++++++++-
>>   1 file changed, 16 insertions(+), 1 deletion(-)
>>
>> diff --git a/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64.dts
>> b/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64.dts
>> index f04f0f1badc4..1d514859e664 100644
>> --- a/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64.dts
>> +++ b/arch/arm64/boot/dts/allwinner/sun50i-a64-pine64.dts
>> @@ -138,6 +138,14 @@ &mmc1 {
>>          mmc-pwrseq = <&wifi_pwrseq>;
>>          bus-width = <4>;
>>          non-removable;
>> +       status = "okay";
>> +
>> +       rtl8723bs: wifi at 1 {
>> +               reg = <1>;
>> +               interrupt-parent = <&r_pio>;
>> +               interrupts = <0 3 IRQ_TYPE_LEVEL_LOW>; /* PL3 */
>> +               interrupt-names = "host-wake";
>> +       };
>>   };
>>   
>>   &ohci0 {
>> @@ -303,7 +311,14 @@ &uart1 {
>>          pinctrl-names = "default";
>>          pinctrl-0 = <&uart1_pins>, <&uart1_rts_cts_pins>;
>>          uart-has-rtscts;
>> -       status = "disabled";
>> +       status = "okay";
>> +
>> +       bluetooth {
>> +               compatible = "realtek,rtl8723bs-bt";
>> +               device-wake-gpios = <&r_pio 0 6 GPIO_ACTIVE_HIGH>; /*
>> PL6 */
>> +               enable-gpios = <&r_pio 0 4 GPIO_ACTIVE_HIGH>; /* PL4
>> */
>> +               host-wake-gpios = <&r_pio 0 5 GPIO_ACTIVE_HIGH>; /*
>> PL5 */
>> +       };
>>   };
>>   
>>   /* On Pi-2 connector */
>