[PATCH 02/11] dt-bindings: pinctrl: Add RaspberryPi RP1 gpio/pinctrl/pinmux bindings

[Andrea della Porta]

Hi Krzysztof,

On 13:46 Fri 30 Aug     , Krzysztof Kozlowski wrote:
> On 30/08/2024 12:22, Andrea della Porta wrote:
> > Hi Krzysztof,
> > 
> 
> ...
> 
> >>> +#define RP1_USBHOST0_AXIS_BASE 0x200000
> >>> +#define RP1_USBHOST1_AXIS_BASE 0x300000
> >>> +#define RP1_EXAC_BASE 0x400000
> >>> +
> >>> +/* Interrupts */
> >>> +
> >>> +#define RP1_INT_IO_BANK0 0
> >>> +#define RP1_INT_IO_BANK1 1
> >>
> >> Also no, interrupt numbers are not considered bindings. That's too much
> >> churn. Otherwise, please point me to driver code using the define
> >> (directly! that's the requirement).
> > 
> > As mentioned above, RP1_INT_END is used in rp1-pci.c. To get rid of all those
> 
> Number of interrupts is not a binding, either. Does not appear in the DTS.

Ack.

> 
> > macroes from dt-binding would mean to hardcode the interrupt number in both
> > the binding example and in dtso, from this:
> > 
> > interrupts = <RP1_INT_IO_BANK0 IRQ_TYPE_LEVEL_HIGH>,
> >              <RP1_INT_IO_BANK1 IRQ_TYPE_LEVEL_HIGH>,
> >              <RP1_INT_IO_BANK2 IRQ_TYPE_LEVEL_HIGH>;
> > 
> > to this:
> > 
> > interrupts = <0 IRQ_TYPE_LEVEL_HIGH>,
> > 	     <1 IRQ_TYPE_LEVEL_HIGH>,
> >              <2 IRQ_TYPE_LEVEL_HIGH>;
> > 
> > is this what you are proposing?
> 
> Yes, just like every DTS does. I think the hard-coding of numbers is not
> a problem.

Ack.

Regards,
Andrea

> 
> Best regards,
> Krzysztof
>