[PATCH v10 4/4] ARM: dts: mxs: Add descriptions for imx287 based btt3-[012] devices

[Stefan Wahren]

Am 31.10.24 um 09:42 schrieb Lukasz Majewski:
> Dear Community,
>
>> The btt3 device' HW revisions from 0 to 2 use imx287 SoC and are to
>> some extend similar to already upstreamed XEA devices, hence are
>> using common imx28-lwe.dtsi file.
>>
>> New, imx28-btt3.dtsi has been added to embrace common DTS
>> properties for different HW revisions for this device.
>>
>> As a result - changes introduced in imx28-btt3-[012].dts are
>> minimal.
>>
>> Signed-off-by: Lukasz Majewski <lukma at denx.de>
>>
>> ---
>> Changes for v2:
>> - Rename dts file from btt3-[012] to imx28-btt3-[012] to match current
>>    linux kernel naming convention
>> - Remove 'wlf,wm8974' from compatible for codec at 1a
>>
>> Changes for v3:
>> - Keep alphabethical order for Makefile entries
>>
>> Changes for v4:
>> - Change compatible for btt3 board (to 'lwn,imx28-btt3')
>>
>> Changes for v5:
>> - Combine patch, which adds btt3-[012] with one adding board entry to
>>    fsl.yaml
>>
>> Changes for v6:
>> - Make the patch series for adding entry in fsl.yaml and btt3
>>
>> Changes for v7:
>> - Use "panel" property as suggested by the community
>> - Use panel-timing to specify the display parameters
>> - Update subject line with correct tags
>>
>> Changes for v8:
>> - Use GPIO_ACTIVE_HIGH instead of '0'
>> - Add the comment regarding mac address specification
>> - Remove superfluous comment
>> - Change wifi-en-pin node name
>>
>> Changes for v9:
>> - Remove not used 'pm-ignore-notify'
>> - Add display names for 'panel-dpi' compatible to avoid Schema
>> warnings
>>
>> Changes for v10:
>> - Drop new line with panel-timing definitions
>> - Add new lines with 'sound' node
>> - Change 'codec' to 'audio-codec'
>> - Change order of properties for saif1 node
> Are there any more comments regarding this patch?
Sorry, i wasn't aware that you are waiting for reviews after Rob's request.