[PATCH v2] ARM: dts: stm32: Describe M24256E write-lockable page in DH STM32MP13xx DHCOR SoM DT

[Alexandre TORGUE]

Hi Marek

On 10/17/24 21:09, Marek Vasut wrote:
> The STM32MP13xx DHCOR SoM is populated with M24256E EEPROM which has
> Additional Write lockable page at separate I2C address. Describe the
> page in DT to make it available.
> 
> Note that the WLP page on this device is hardware write-protected by
> R37 which pulls the nWC signal high to VDD_3V3_1V8 power rail.
> 
> Signed-off-by: Marek Vasut <marex at denx.de>
> ---
> Cc: Alexandre Torgue <alexandre.torgue at foss.st.com>
> Cc: Christoph Niedermaier <cniedermaier at dh-electronics.com>
> Cc: Conor Dooley <conor+dt at kernel.org>
> Cc: Krzysztof Kozlowski <krzk+dt at kernel.org>
> Cc: Maxime Coquelin <mcoquelin.stm32 at gmail.com>
> Cc: Rob Herring <robh at kernel.org>
> Cc: devicetree at vger.kernel.org
> Cc: kernel at dh-electronics.com
> Cc: linux-arm-kernel at lists.infradead.org
> Cc: linux-kernel at vger.kernel.org
> Cc: linux-stm32 at st-md-mailman.stormreply.com
> ---
> V2: Fix up the M25256E in Subject
> ---
> DEPENDS:
> - https://lore.kernel.org/linux-i2c/20241017184152.128395-1-marex@denx.de/
> - https://lore.kernel.org/linux-i2c/20241017184152.128395-2-marex@denx.de/
> ---
>   arch/arm/boot/dts/st/stm32mp13xx-dhcor-som.dtsi | 6 ++++++
>   1 file changed, 6 insertions(+)
> 
> diff --git a/arch/arm/boot/dts/st/stm32mp13xx-dhcor-som.dtsi b/arch/arm/boot/dts/st/stm32mp13xx-dhcor-som.dtsi
> index 5c633ed548f37..07133bd82efa6 100644
> --- a/arch/arm/boot/dts/st/stm32mp13xx-dhcor-som.dtsi
> +++ b/arch/arm/boot/dts/st/stm32mp13xx-dhcor-som.dtsi
> @@ -202,6 +202,12 @@ eeprom0: eeprom at 50 {
>   		pagesize = <64>;
>   	};
>   
> +	eeprom0wl: eeprom at 58 {
> +		compatible = "st,24256e-wl";	/* ST M24256E WL page of 0x50 */
> +		pagesize = <64>;
> +		reg = <0x58>;
> +	};
> +

You could have sorted nodes by I2C addresses.
Anyway, applied on stm32-next (as dependencies have been applied by 
Bartosz).

Cheers
Alex


>   	rv3032: rtc at 51 {
>   		compatible = "microcrystal,rv3032";
>   		reg = <0x51>;