[PATCH 1/1] RFC: dt bindings: Add property "brcm,gen3-eq-presets"
Krishna Chaitanya Chundru
quic_krichai at quicinc.com
Thu Oct 24 18:08:37 PDT 2024
On 10/22/2024 12:33 AM, Rob Herring wrote:
> On Fri, Oct 18, 2024 at 02:22:45PM -0400, Jim Quinlan wrote:
>> Support configuration of the GEN3 preset equalization settings, aka the
>> Lane Equalization Control Register(s) of the Secondary PCI Express
>> Extended Capability. These registers are of type HwInit/RsvdP and
>> typically set by FW. In our case they are set by our RC host bridge
>> driver using internal registers.
>>
>> Signed-off-by: Jim Quinlan <james.quinlan at broadcom.com>
>> ---
>> .../devicetree/bindings/pci/brcm,stb-pcie.yaml | 12 ++++++++++++
>> 1 file changed, 12 insertions(+)
>>
>> diff --git a/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml b/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml
>> index 0925c520195a..f965ad57f32f 100644
>> --- a/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml
>> +++ b/Documentation/devicetree/bindings/pci/brcm,stb-pcie.yaml
>> @@ -104,6 +104,18 @@ properties:
>> minItems: 1
>> maxItems: 3
>>
>> + brcm,gen3-eq-presets:
>> + description: |
>> + A u16 array giving the GEN3 equilization presets, one for each lane.
>> + These values are destined for the 16bit registers known as the
>> + Lane Equalization Control Register(s) of the Secondary PCI Express
>> + Extended Capability. In the array, lane 0 is first term, lane 1 next,
>> + etc. The contents of the entries reflect what is necessary for
>> + the current board and SoC, and the details of each preset are
>> + described in Section 7.27.4 of the PCI base spec, Revision 3.0.
>
> If these are defined by the PCIe spec, then why is it Broadcom specific
> property?
>
Hi Rob,
qcom pcie driver also needs to program these presets as you suggested
this can go to common pci bridge binding.
from PCIe spec 6.0.1 revision section 8.3.3.3 & 4.2.4.2 for data rates
of 8.0 GT/s, 16.0 GT/s, and 32.0 GT/s uses one class of preset (P0
through P10) and where as data rates of 64.0 GT/s use different class of
presets (Q0 through Q10) (Table 4-23). And data rates of 8.0 GT/s also
have optional preset hints (Table 4-24).
And there is possibility that for each data rate we may require
different preset configuration.
Can we have a dt binding for each data rate of 16 byte array.
like gen3-eq-preset array, gen4-eq-preset array etc.
- Krishna Chaitanya
>> +
>> + $ref: /schemas/types.yaml#/definitions/uint16-array
>
> minItems: 1
> maxItems: 16
>
> Last I saw, you can only have up to 16 lanes.
>
> Rob
>
More information about the linux-arm-kernel
mailing list