[PATCH net-next v2 2/4] net: hsr: Add VLAN CTAG filter support

MD Danish Anwar danishanwar at ti.com
Thu Oct 24 03:30:54 PDT 2024


From: Murali Karicheri <m-karicheri2 at ti.com>

This patch adds support for VLAN ctag based filtering at slave devices.
The slave ethernet device may be capable of filtering ethernet packets
based on VLAN ID. This requires that when the VLAN interface is created
over an HSR/PRP interface, it passes the VID information to the
associated slave ethernet devices so that it updates the hardware
filters to filter ethernet frames based on VID. This patch adds the
required functions to propagate the vid information to the slave
devices.

Signed-off-by: Murali Karicheri <m-karicheri2 at ti.com>
Signed-off-by: MD Danish Anwar <danishanwar at ti.com>
---
 net/hsr/hsr_device.c | 71 +++++++++++++++++++++++++++++++++++++++++++-
 1 file changed, 70 insertions(+), 1 deletion(-)

diff --git a/net/hsr/hsr_device.c b/net/hsr/hsr_device.c
index 0ca47ebb01d3..ff586bdc2bde 100644
--- a/net/hsr/hsr_device.c
+++ b/net/hsr/hsr_device.c
@@ -515,6 +515,68 @@ static void hsr_change_rx_flags(struct net_device *dev, int change)
 	}
 }
 
+static int hsr_ndo_vlan_rx_add_vid(struct net_device *dev,
+				   __be16 proto, u16 vid)
+{
+	struct hsr_port *port;
+	struct hsr_priv *hsr;
+	int ret = 0;
+
+	hsr = netdev_priv(dev);
+
+	hsr_for_each_port(hsr, port) {
+		if (port->type == HSR_PT_MASTER)
+			continue;
+
+		ret = vlan_vid_add(port->dev, proto, vid);
+		switch (port->type) {
+		case HSR_PT_SLAVE_A:
+			if (ret) {
+				netdev_err(dev, "add vid failed for Slave-A\n");
+				return ret;
+			}
+			break;
+
+		case HSR_PT_SLAVE_B:
+			if (ret) {
+				/* clean up Slave-A */
+				netdev_err(dev, "add vid failed for Slave-B\n");
+				vlan_vid_del(port->dev, proto, vid);
+				return ret;
+			}
+			break;
+		default:
+			break;
+		}
+	}
+
+	return 0;
+}
+
+static int hsr_ndo_vlan_rx_kill_vid(struct net_device *dev,
+				    __be16 proto, u16 vid)
+{
+	struct hsr_port *port;
+	struct hsr_priv *hsr;
+
+	hsr = netdev_priv(dev);
+
+	hsr_for_each_port(hsr, port) {
+		if (port->type == HSR_PT_MASTER)
+			continue;
+		switch (port->type) {
+		case HSR_PT_SLAVE_A:
+		case HSR_PT_SLAVE_B:
+			vlan_vid_del(port->dev, proto, vid);
+			break;
+		default:
+			break;
+		}
+	}
+
+	return 0;
+}
+
 static const struct net_device_ops hsr_device_ops = {
 	.ndo_change_mtu = hsr_dev_change_mtu,
 	.ndo_open = hsr_dev_open,
@@ -523,6 +585,8 @@ static const struct net_device_ops hsr_device_ops = {
 	.ndo_change_rx_flags = hsr_change_rx_flags,
 	.ndo_fix_features = hsr_fix_features,
 	.ndo_set_rx_mode = hsr_set_rx_mode,
+	.ndo_vlan_rx_add_vid = hsr_ndo_vlan_rx_add_vid,
+	.ndo_vlan_rx_kill_vid = hsr_ndo_vlan_rx_kill_vid,
 };
 
 static const struct device_type hsr_type = {
@@ -569,7 +633,8 @@ void hsr_dev_setup(struct net_device *dev)
 
 	dev->hw_features = NETIF_F_SG | NETIF_F_FRAGLIST | NETIF_F_HIGHDMA |
 			   NETIF_F_GSO_MASK | NETIF_F_HW_CSUM |
-			   NETIF_F_HW_VLAN_CTAG_TX;
+			   NETIF_F_HW_VLAN_CTAG_TX |
+			   NETIF_F_HW_VLAN_CTAG_FILTER;
 
 	dev->features = dev->hw_features;
 }
@@ -647,6 +712,10 @@ int hsr_dev_finalize(struct net_device *hsr_dev, struct net_device *slave[2],
 	    (slave[1]->features & NETIF_F_HW_HSR_FWD))
 		hsr->fwd_offloaded = true;
 
+	if ((slave[0]->features & NETIF_F_HW_VLAN_CTAG_FILTER) &&
+	    (slave[1]->features & NETIF_F_HW_VLAN_CTAG_FILTER))
+		hsr_dev->features |= NETIF_F_HW_VLAN_CTAG_FILTER;
+
 	res = register_netdevice(hsr_dev);
 	if (res)
 		goto err_unregister;
-- 
2.34.1




More information about the linux-arm-kernel mailing list