[PATCH v5 05/12] arm64: dts: ti: k3-j721e: Add bootph-* properties

[Manorit Chawdhry]

Adds bootph-* properties to the leaf nodes to enable bootloaders to
utilise them.

Following adds bootph-* to
- System controller nodes that allow controlling power domain, clocks, etc.
- secure_proxy_sa3/secure_proxy_main mboxes for communication with
  System Controller
- mcu_ringacc/mcu_udmap for DMA to SMS
- chipid for detection soc information.
- mcu_timer0 for bootloader tick-timer.
- hbmc_mux for enabling Hyperflash support
- ESM nodes for enabling ESM support.
- wkup_vtm for enabling Adaptive voltage scaling(AVS) support

Signed-off-by: Manorit Chawdhry <m-chawdhry at ti.com>
---
 arch/arm64/boot/dts/ti/k3-j721e-main.dtsi       |  2 ++
 arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi | 10 ++++++++++
 2 files changed, 12 insertions(+)

diff --git a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
index 0da785be80ff..af3d730154ac 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j721e-main.dtsi
@@ -226,6 +226,7 @@ secure_proxy_main: mailbox at 32c00000 {
 			      <0x00 0x32800000 0x00 0x100000>;
 			interrupt-names = "rx_011";
 			interrupts = <GIC_SPI 37 IRQ_TYPE_LEVEL_HIGH>;
+			bootph-all;
 		};
 
 		smmu0: iommu at 36600000 {
@@ -2853,6 +2854,7 @@ main_spi7: spi at 2170000 {
 	main_esm: esm at 700000 {
 		compatible = "ti,j721e-esm";
 		reg = <0x0 0x700000 0x0 0x1000>;
+		bootph-pre-ram;
 		ti,esm-pins = <344>, <345>;
 	};
 };
diff --git a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
index 3731ffb4a5c9..cf5fb1160ada 100644
--- a/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j721e-mcu-wakeup.dtsi
@@ -21,16 +21,19 @@ dmsc: system-controller at 44083000 {
 		k3_pds: power-controller {
 			compatible = "ti,sci-pm-domain";
 			#power-domain-cells = <2>;
+			bootph-all;
 		};
 
 		k3_clks: clock-controller {
 			compatible = "ti,k2g-sci-clk";
 			#clock-cells = <2>;
+			bootph-all;
 		};
 
 		k3_reset: reset-controller {
 			compatible = "ti,sci-reset";
 			#reset-cells = <2>;
+			bootph-all;
 		};
 	};
 
@@ -61,6 +64,7 @@ wkup_conf: bus at 43000000 {
 		chipid: chipid at 14 {
 			compatible = "ti,am654-chipid";
 			reg = <0x14 0x4>;
+			bootph-all;
 		};
 	};
 
@@ -112,6 +116,7 @@ mcu_timer0: timer at 40400000 {
 		assigned-clocks = <&k3_clks 35 1>;
 		assigned-clock-parents = <&k3_clks 35 2>;
 		power-domains = <&k3_pds 35 TI_SCI_PD_EXCLUSIVE>;
+		bootph-pre-ram;
 		ti,timer-pwm;
 		/* Non-MPU Firmware usage */
 		status = "reserved";
@@ -362,6 +367,7 @@ hbmc_mux: mux-controller at 47000004 {
 			reg = <0x00 0x47000004 0x00 0x4>;
 			#mux-control-cells = <1>;
 			mux-reg-masks = <0x0 0x2>; /* HBMC select */
+			bootph-all;
 		};
 
 		hbmc: hyperbus at 47034000 {
@@ -470,6 +476,7 @@ mcu_ringacc: ringacc at 2b800000 {
 			      <0x0 0x2a500000 0x0 0x40000>,
 			      <0x0 0x28440000 0x0 0x40000>;
 			reg-names = "rt", "fifos", "proxy_gcfg", "proxy_target", "cfg";
+			bootph-all;
 			ti,num-rings = <286>;
 			ti,sci-rm-range-gp-rings = <0x1>; /* GP ring range */
 			ti,sci = <&dmsc>;
@@ -489,6 +496,7 @@ mcu_udmap: dma-controller at 285c0000 {
 				    "tchan", "rchan", "rflow";
 			msi-parent = <&main_udmass_inta>;
 			#dma-cells = <1>;
+			bootph-all;
 
 			ti,sci = <&dmsc>;
 			ti,sci-dev-id = <236>;
@@ -509,6 +517,7 @@ secure_proxy_mcu: mailbox at 2a480000 {
 		reg = <0x0 0x2a480000 0x0 0x80000>,
 		      <0x0 0x2a380000 0x0 0x80000>,
 		      <0x0 0x2a400000 0x0 0x80000>;
+		bootph-pre-ram;
 		/*
 		 * Marked Disabled:
 		 * Node is incomplete as it is meant for bootloaders and
@@ -687,6 +696,7 @@ wkup_vtm0: temperature-sensor at 42040000 {
 		      <0x00 0x43000300 0x00 0x10>;
 		power-domains = <&k3_pds 154 TI_SCI_PD_EXCLUSIVE>;
 		#thermal-sensor-cells = <1>;
+		bootph-pre-ram;
 	};
 
 	mcu_esm: esm at 40800000 {

-- 
2.46.0