[PATCH 0/8] ARM: dts: Add some BCM6846 device tree

[Rob Herring (Arm)]

On Fri, 11 Oct 2024 00:06:58 +0200, Linus Walleij wrote:
> This adds some silicon blocks to the BCM6846 DTSI file and
> adds a device tree for the Genexis XG6846B device that
> make use of it.
> 
> This is mainly so as to get this off my hard drive and
> share the basics with others who want to work on the
> BCM6846.
> 
> I think most of the DTSI changes can be just copied verbatim
> to the rest of the BCMBCA family (maybe extracted into a
> common bcbca.dtsi?) but let's think about that later.
> This will do for now.
> 
> The XG6846B device tree uses the new shift register bits
> property of the BCM63138 LEDs, which is ACKed by the
> DT maintainers albeit not yet merged in the LED tree.
> 
> Signed-off-by: Linus Walleij <linus.walleij at linaro.org>
> ---
> Linus Walleij (8):
>       ARM: dts: bcm6846: Add iproc rng
>       ARM: dts: bcm6846: Enable watchdog
>       ARM: dts: bcm6846: Add GPIO blocks
>       ARM: dts: bcm6846: Add MDIO control block
>       ARM: dts: bcm6846: Add LED controller
>       dt-bindings: vendor-prefixes: Add Genexis
>       dt-bindings: arm: bcmbca: Add Genexis XG6846B
>       ARM: dts: broadcom: Add Genexis XG6846B DTS file
> 
>  .../devicetree/bindings/arm/bcm/brcm,bcmbca.yaml   |   1 +
>  .../devicetree/bindings/vendor-prefixes.yaml       |   2 +
>  arch/arm/boot/dts/broadcom/Makefile                |   1 +
>  .../boot/dts/broadcom/bcm6846-genexis-xg6846b.dts  | 244 +++++++++++++++++++++
>  arch/arm/boot/dts/broadcom/bcm6846.dtsi            | 107 +++++++++
>  5 files changed, 355 insertions(+)
> ---
> base-commit: 9852d85ec9d492ebef56dc5f229416c925758edc
> change-id: 20241010-genexis-xg6846b-base-ef3fbec0be01
> 
> Best regards,
> --
> Linus Walleij <linus.walleij at linaro.org>
> 
> 
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y broadcom/bcm6846-genexis-xg6846b.dtb' for 20241011-genexis-xg6846b-base-v1-0-f04d6f6f93ce at linaro.org:

arch/arm/boot/dts/broadcom/bcm6846-genexis-xg6846b.dtb: gpio at 508: 'ngpios' does not match any of the regexes: 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/gpio/gpio-mmio.yaml#
arch/arm/boot/dts/broadcom/bcm6846-genexis-xg6846b.dtb: mdio at 2060: #address-cells: 1 was expected
	from schema $id: http://devicetree.org/schemas/net/brcm,unimac-mdio.yaml#
arch/arm/boot/dts/broadcom/bcm6846-genexis-xg6846b.dtb: mdio at 2060: #size-cells: 0 was expected
	from schema $id: http://devicetree.org/schemas/net/brcm,unimac-mdio.yaml#
arch/arm/boot/dts/broadcom/bcm6846-genexis-xg6846b.dtb: mdio at 2060: Unevaluated properties are not allowed ('#address-cells', '#size-cells', 'ethernet-phy at 1', 'ethernet-phy at 2', 'ethernet-phy at 21', 'ethernet-phy at 3', 'ethernet-phy at 4' were unexpected)
	from schema $id: http://devicetree.org/schemas/net/brcm,unimac-mdio.yaml#
arch/arm/boot/dts/broadcom/bcm6846-genexis-xg6846b.dtb: mdio at 2060: #address-cells: 1 was expected
	from schema $id: http://devicetree.org/schemas/net/mdio.yaml#
arch/arm/boot/dts/broadcom/bcm6846-genexis-xg6846b.dtb: mdio at 2060: #size-cells: 0 was expected
	from schema $id: http://devicetree.org/schemas/net/mdio.yaml#