[PATCH v1] mmc: Fix typos in comments across various files
Ulf Hansson
ulf.hansson at linaro.org
Tue Oct 8 07:35:54 PDT 2024
On Sun, 29 Sept 2024 at 11:34, Yu Jiaoliang <yujiaoliang at vivo.com> wrote:
>
> This patch corrects several typos in comments within the mmc/host
> directory. No functional changes are introduced, only comment
> improvements for better readability.
>
> Detected using codespell.
>
> Signed-off-by: Yu Jiaoliang <yujiaoliang at vivo.com>
Applied for next, thanks!
Kind regards
Uffe
> ---
> drivers/mmc/host/atmel-mci.c | 2 +-
> drivers/mmc/host/au1xmmc.c | 2 +-
> drivers/mmc/host/cavium-octeon.c | 2 +-
> drivers/mmc/host/dw_mmc.c | 2 +-
> drivers/mmc/host/meson-gx-mmc.c | 2 +-
> drivers/mmc/host/mmci.h | 2 +-
> drivers/mmc/host/sdhci-esdhc-imx.c | 4 ++--
> drivers/mmc/host/sdhci-msm.c | 2 +-
> 8 files changed, 9 insertions(+), 9 deletions(-)
>
> diff --git a/drivers/mmc/host/atmel-mci.c b/drivers/mmc/host/atmel-mci.c
> index 6490df54a6f5..f444ca5dd154 100644
> --- a/drivers/mmc/host/atmel-mci.c
> +++ b/drivers/mmc/host/atmel-mci.c
> @@ -860,7 +860,7 @@ static void atmci_send_stop_cmd(struct atmel_mci *host, struct mmc_data *data)
> }
>
> /*
> - * Configure given PDC buffer taking care of alignement issues.
> + * Configure given PDC buffer taking care of alignment issues.
> * Update host->data_size and host->sg.
> */
> static void atmci_pdc_set_single_buf(struct atmel_mci *host,
> diff --git a/drivers/mmc/host/au1xmmc.c b/drivers/mmc/host/au1xmmc.c
> index 6e80bcb668ec..7393d2ea5e57 100644
> --- a/drivers/mmc/host/au1xmmc.c
> +++ b/drivers/mmc/host/au1xmmc.c
> @@ -543,7 +543,7 @@ static void au1xmmc_cmd_complete(struct au1xmmc_host *host, u32 status)
> cmd->resp[i] |= (r[i + 1] & 0xFF000000) >> 24;
> }
> } else {
> - /* Techincally, we should be getting all 48 bits of
> + /* Technically, we should be getting all 48 bits of
> * the response (SD_RESP1 + SD_RESP2), but because
> * our response omits the CRC, our data ends up
> * being shifted 8 bits to the right. In this case,
> diff --git a/drivers/mmc/host/cavium-octeon.c b/drivers/mmc/host/cavium-octeon.c
> index 060ec4f4800f..d150d83b41ed 100644
> --- a/drivers/mmc/host/cavium-octeon.c
> +++ b/drivers/mmc/host/cavium-octeon.c
> @@ -217,7 +217,7 @@ static int octeon_mmc_probe(struct platform_device *pdev)
> return PTR_ERR(base);
> host->dma_base = base;
> /*
> - * To keep the register addresses shared we intentionaly use
> + * To keep the register addresses shared we intentionally use
> * a negative offset here, first register used on Octeon therefore
> * starts at 0x20 (MIO_EMM_DMA_CFG).
> */
> diff --git a/drivers/mmc/host/dw_mmc.c b/drivers/mmc/host/dw_mmc.c
> index 41e451235f63..aab1a8df6414 100644
> --- a/drivers/mmc/host/dw_mmc.c
> +++ b/drivers/mmc/host/dw_mmc.c
> @@ -1182,7 +1182,7 @@ static void dw_mci_submit_data(struct dw_mci *host, struct mmc_data *data)
> /*
> * Use the initial fifoth_val for PIO mode. If wm_algined
> * is set, we set watermark same as data size.
> - * If next issued data may be transfered by DMA mode,
> + * If next issued data may be transferred by DMA mode,
> * prev_blksz should be invalidated.
> */
> if (host->wm_aligned)
> diff --git a/drivers/mmc/host/meson-gx-mmc.c b/drivers/mmc/host/meson-gx-mmc.c
> index c7c067b9415a..e87d1c4b9dc1 100644
> --- a/drivers/mmc/host/meson-gx-mmc.c
> +++ b/drivers/mmc/host/meson-gx-mmc.c
> @@ -879,7 +879,7 @@ static void meson_mmc_request(struct mmc_host *mmc, struct mmc_request *mrq)
> /*
> * The memory at the end of the controller used as bounce buffer for
> * the dram_access_quirk only accepts 32bit read/write access,
> - * check the aligment and length of the data before starting the request.
> + * check the alignment and length of the data before starting the request.
> */
> if (host->dram_access_quirk && mrq->data) {
> mrq->cmd->error = meson_mmc_validate_dram_access(mmc, mrq->data);
> diff --git a/drivers/mmc/host/mmci.h b/drivers/mmc/host/mmci.h
> index a5eb4ced4d5d..4d3647f9ec06 100644
> --- a/drivers/mmc/host/mmci.h
> +++ b/drivers/mmc/host/mmci.h
> @@ -77,7 +77,7 @@
> #define MCI_CPSM_INTERRUPT BIT(8)
> #define MCI_CPSM_PENDING BIT(9)
> #define MCI_CPSM_ENABLE BIT(10)
> -/* Command register flag extenstions in the ST Micro versions */
> +/* Command register flag extensions in the ST Micro versions */
> #define MCI_CPSM_ST_SDIO_SUSP BIT(11)
> #define MCI_CPSM_ST_ENCMD_COMPL BIT(12)
> #define MCI_CPSM_ST_NIEN BIT(13)
> diff --git a/drivers/mmc/host/sdhci-esdhc-imx.c b/drivers/mmc/host/sdhci-esdhc-imx.c
> index 8f0bc6dca2b0..2bfb86364441 100644
> --- a/drivers/mmc/host/sdhci-esdhc-imx.c
> +++ b/drivers/mmc/host/sdhci-esdhc-imx.c
> @@ -1524,7 +1524,7 @@ static void sdhci_esdhc_imx_hwinit(struct sdhci_host *host)
> writel(tmp, host->ioaddr + ESDHC_TUNING_CTRL);
> } else if (imx_data->socdata->flags & ESDHC_FLAG_MAN_TUNING) {
> /*
> - * ESDHC_STD_TUNING_EN may be configed in bootloader
> + * ESDHC_STD_TUNING_EN may be configured in bootloader
> * or ROM code, so clear this bit here to make sure
> * the manual tuning can work.
> */
> @@ -1626,7 +1626,7 @@ sdhci_esdhc_imx_probe_dt(struct platform_device *pdev,
>
> /*
> * If we have this property, then activate WP check.
> - * Retrieveing and requesting the actual WP GPIO will happen
> + * Retrieving and requesting the actual WP GPIO will happen
> * in the call to mmc_of_parse().
> */
> if (of_property_read_bool(np, "wp-gpios"))
> diff --git a/drivers/mmc/host/sdhci-msm.c b/drivers/mmc/host/sdhci-msm.c
> index e113b99a3eab..d6b3b343b031 100644
> --- a/drivers/mmc/host/sdhci-msm.c
> +++ b/drivers/mmc/host/sdhci-msm.c
> @@ -2601,7 +2601,7 @@ static int sdhci_msm_probe(struct platform_device *pdev)
> sdhci_msm_handle_pwr_irq(host, 0);
>
> /*
> - * Ensure that above writes are propogated before interrupt enablement
> + * Ensure that above writes are propagated before interrupt enablement
> * in GIC.
> */
> mb();
> --
> 2.34.1
>
More information about the linux-arm-kernel
mailing list