[PATCH v2 2/4] media: i2c: imx290: Register 0x3011 varies between imx327 and imx290

[Laurent Pinchart]

Hi Dave,

Thank you for the patch.

On Wed, Nov 20, 2024 at 07:17:04PM +0000, Dave Stevenson wrote:
> Reviewing the datasheets, register 0x3011 is meant to be 0x02 on imx327
> and 0x00 on imx290.
> 
> Move it out of the common registers, and set it appropriately in the
> sensor specific sections. (Included for imx290 to be explicit, rather
> than relying on the default value).
> 
> Fixes: 2d41947ec2c0 ("media: i2c: imx290: Add support for imx327 variant")
> Signed-off-by: Dave Stevenson <dave.stevenson at raspberrypi.com>

Reviewed-by: Laurent Pinchart <laurent.pinchart at ideasonboard.com>

> ---
>  drivers/media/i2c/imx290.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/media/i2c/imx290.c b/drivers/media/i2c/imx290.c
> index da654deb444a..7d794a509670 100644
> --- a/drivers/media/i2c/imx290.c
> +++ b/drivers/media/i2c/imx290.c
> @@ -268,7 +268,6 @@ static const struct cci_reg_sequence imx290_global_init_settings[] = {
>  	{ IMX290_WINWV, 1097 },
>  	{ IMX290_XSOUTSEL, IMX290_XSOUTSEL_XVSOUTSEL_VSYNC |
>  			   IMX290_XSOUTSEL_XHSOUTSEL_HSYNC },
> -	{ CCI_REG8(0x3011), 0x02 },
>  	{ CCI_REG8(0x3012), 0x64 },
>  	{ CCI_REG8(0x3013), 0x00 },
>  };
> @@ -276,6 +275,7 @@ static const struct cci_reg_sequence imx290_global_init_settings[] = {
>  static const struct cci_reg_sequence imx290_global_init_settings_290[] = {
>  	{ CCI_REG8(0x300f), 0x00 },
>  	{ CCI_REG8(0x3010), 0x21 },
> +	{ CCI_REG8(0x3011), 0x00 },
>  	{ CCI_REG8(0x3016), 0x09 },
>  	{ CCI_REG8(0x3070), 0x02 },
>  	{ CCI_REG8(0x3071), 0x11 },
> @@ -329,6 +329,7 @@ static const struct cci_reg_sequence xclk_regs[][IMX290_NUM_CLK_REGS] = {
>  };
>  
>  static const struct cci_reg_sequence imx290_global_init_settings_327[] = {
> +	{ CCI_REG8(0x3011), 0x02 },
>  	{ CCI_REG8(0x309e), 0x4A },
>  	{ CCI_REG8(0x309f), 0x4A },
>  	{ CCI_REG8(0x313b), 0x61 },

-- 
Regards,

Laurent Pinchart