[PATCH v2 2/6] arm64: dts: qcom: Add pmd8028 and pmih0108 PMICs

[Dmitry Baryshkov]

On Mon, Nov 11, 2024 at 04:49:32PM -0800, Melody Olvera wrote:
> From: Jishnu Prakash <quic_jprakash at quicinc.com>
> 
> Add descriptions of pmd8028 and pmih0108 PMICs used on SM8750
> platforms.

Up/lower case?

> 
> Signed-off-by: Jishnu Prakash <quic_jprakash at quicinc.com>
> Signed-off-by: Melody Olvera <quic_molvera at quicinc.com>
> ---
>  arch/arm64/boot/dts/qcom/pmd8028.dtsi  | 56 +++++++++++++++++++++++
>  arch/arm64/boot/dts/qcom/pmih0108.dtsi | 62 ++++++++++++++++++++++++++

Those two are independent changes. Please use two separate patches.

>  2 files changed, 118 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pmd8028.dtsi
>  create mode 100644 arch/arm64/boot/dts/qcom/pmih0108.dtsi
> 
> diff --git a/arch/arm64/boot/dts/qcom/pmd8028.dtsi b/arch/arm64/boot/dts/qcom/pmd8028.dtsi
> new file mode 100644
> index 000000000000..f8ef8e133854
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pmd8028.dtsi
> @@ -0,0 +1,56 @@
> +// SPDX-License-Identifier: BSD-3-Clause
> +/*
> + * Copyright (c) 2024 Qualcomm Innovation Center, Inc. All rights reserved.
> + */
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +/ {
> +	thermal-zones {
> +		pmd8028-thermal {
> +			polling-delay-passive = <100>;
> +			thermal-sensors = <&pmd8028_temp_alarm>;
> +
> +			trips {
> +				pmd8028_trip0: trip0 {
> +					temperature = <95000>;
> +					hysteresis = <0>;
> +					type = "passive";
> +				};
> +
> +				pmd8028_trip1: trip1 {
> +					temperature = <115000>;
> +					hysteresis = <0>;
> +					type = "hot";

"critical" ?

> +				};
> +			};
> +		};
> +	};
> +};
> +
> +&spmi_bus {
> +	pmd8028: pmic at 4 {
> +		compatible = "qcom,pmd8028", "qcom,spmi-pmic";
> +		reg = <0x4 SPMI_USID>;
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		pmd8028_temp_alarm: temp-alarm at a00 {
> +			compatible = "qcom,spmi-temp-alarm";
> +			reg = <0xa00>;
> +			interrupts = <0x4 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
> +			#thermal-sensor-cells = <0>;
> +		};
> +
> +		pmd8028_gpios: gpio at 8800 {
> +			compatible = "qcom,pmd8028-gpio", "qcom,spmi-gpio";
> +			reg = <0x8800>;
> +			gpio-controller;
> +			gpio-ranges = <&pmd8028_gpios 0 0 4>;
> +			#gpio-cells = <2>;
> +			interrupt-controller;
> +			#interrupt-cells = <2>;
> +		};
> +	};
> +};
> diff --git a/arch/arm64/boot/dts/qcom/pmih0108.dtsi b/arch/arm64/boot/dts/qcom/pmih0108.dtsi
> new file mode 100644
> index 000000000000..3907d8fbcf78
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pmih0108.dtsi
> @@ -0,0 +1,62 @@
> +// SPDX-License-Identifier: BSD-3-Clause
> +/*
> + * Copyright (c) 2024 Qualcomm Innovation Center, Inc. All rights reserved.
> + */
> +
> +#include <dt-bindings/interrupt-controller/irq.h>
> +#include <dt-bindings/spmi/spmi.h>
> +
> +/ {
> +	thermal-zones {
> +		pmih0108-thermal {
> +			polling-delay-passive = <100>;
> +			thermal-sensors = <&pmih0108_temp_alarm>;
> +
> +			trips {
> +				trip0 {
> +					temperature = <95000>;
> +					hysteresis = <0>;
> +					type = "passive";
> +				};
> +
> +				trip1 {
> +					temperature = <115000>;
> +					hysteresis = <0>;
> +					type = "hot";

"critical" ?

> +				};
> +			};
> +		};
> +	};
> +};
> +
> +&spmi_bus {
> +	pmih0108: pmic at 7 {
> +		compatible = "qcom,pmih0108", "qcom,spmi-pmic";
> +		reg = <0x7 SPMI_USID>;
> +		#address-cells = <1>;
> +		#size-cells = <0>;
> +
> +		pmih0108_temp_alarm: temp-alarm at a00 {
> +			compatible = "qcom,spmi-temp-alarm";
> +			reg = <0xa00>;
> +			interrupts = <0x7 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
> +			#thermal-sensor-cells = <0>;
> +		};
> +
> +		pmih0108_gpios: gpio at 8800 {
> +			compatible = "qcom,pmih0108-gpio", "qcom,spmi-gpio";
> +			reg = <0x8800>;
> +			gpio-controller;
> +			gpio-ranges = <&pmih0108_gpios 0 0 18>;
> +			#gpio-cells = <2>;
> +			interrupt-controller;
> +			#interrupt-cells = <2>;
> +		};
> +
> +		pmih0108_eusb2_repeater: phy at fd00 {
> +			compatible = "qcom,pm8550b-eusb2-repeater";
> +			reg = <0xfd00>;
> +			#phy-cells = <0>;
> +		};
> +	};
> +};
> -- 
> 2.46.1
> 

-- 
With best wishes
Dmitry