[PATCH net-next 2/2] net: stmmac: dwmac-qcom-ethqos: Enable support for 2500BASEX
Andrew Lunn
andrew at lunn.ch
Fri May 24 09:07:15 PDT 2024
On Fri, May 24, 2024 at 06:36:53PM +0530, Sneh Shah wrote:
> With integrated PCS qcom mac supports both SGMII and 2500BASEX mode.
> Implement get_interfaces to add support for 2500BASEX.
I don't know this driver very well..... but
/* PCS defines */
#define STMMAC_PCS_RGMII (1 << 0)
#define STMMAC_PCS_SGMII (1 << 1)
#define STMMAC_PCS_TBI (1 << 2)
#define STMMAC_PCS_RTBI (1 << 3)
static int stmmac_ethtool_get_link_ksettings(struct net_device *dev,
struct ethtool_link_ksettings *cmd)
{
struct stmmac_priv *priv = netdev_priv(dev);
if (!(priv->plat->flags & STMMAC_FLAG_HAS_INTEGRATED_PCS) &&
(priv->hw->pcs & STMMAC_PCS_RGMII ||
priv->hw->pcs & STMMAC_PCS_SGMII)) {
struct rgmii_adv adv;
u32 supported, advertising, lp_advertising;
if (!priv->xstats.pcs_link) {
cmd->base.speed = SPEED_UNKNOWN;
cmd->base.duplex = DUPLEX_UNKNOWN;
return 0;
}
/**
* stmmac_check_pcs_mode - verify if RGMII/SGMII is supported
* @priv: driver private structure
* Description: this is to verify if the HW supports the PCS.
* Physical Coding Sublayer (PCS) interface that can be used when the MAC is
* configured for the TBI, RTBI, or SGMII PHY interface.
*/
static void stmmac_check_pcs_mode(struct stmmac_priv *priv)
{
int interface = priv->plat->mac_interface;
if (priv->dma_cap.pcs) {
if ((interface == PHY_INTERFACE_MODE_RGMII) ||
(interface == PHY_INTERFACE_MODE_RGMII_ID) ||
(interface == PHY_INTERFACE_MODE_RGMII_RXID) ||
(interface == PHY_INTERFACE_MODE_RGMII_TXID)) {
netdev_dbg(priv->dev, "PCS RGMII support enabled\n");
priv->hw->pcs = STMMAC_PCS_RGMII;
} else if (interface == PHY_INTERFACE_MODE_SGMII) {
netdev_dbg(priv->dev, "PCS SGMII support enabled\n");
priv->hw->pcs = STMMAC_PCS_SGMII;
}
}
}
I get the feeling this is a minimal hack, rather than a proper
solution.
Andrew
---
pw-bot: cr
More information about the linux-arm-kernel
mailing list