[PATCH v4 0/4] arm64/mm: Enable userfaultfd write-protect

[Anshuman Khandual]

On 5/7/24 16:37, Will Deacon wrote:
> Hi Ryan,
> 
> On Fri, May 03, 2024 at 03:45:58PM +0100, Ryan Roberts wrote:
>> This series adds uffd write-protect support for arm64.
>>
>> Previous attempts to add uffd-wp (and soft-dirty) have failed because of a
>> perceived lack of available PTE SW bits. However it actually turns out that
>> there are 2 available but they are hidden. PTE_PROT_NONE was previously
>> occupying a SW bit, but can be moved, freeing up the SW bit. Bit 63 is marked as
>> "IGNORED" in the Arm ARM, but it does not currently indicate "reserved for SW
>> use" like it does for the other SW bits. I've confirmed with the spec owner that
>> this is an oversight; the bit is intended to be reserved for SW use and the spec
>> will clarify this in a future update.
>>
>> So now we have two spare bits; patch 4 enables uffd-wp on arm64, using the SW
>> bit freed up by moving PTE_PROT_NONE. This leaves bit 63 spare for future use
>> (e.g. soft-dirty - see RFC at [4] - or some other usage).
>>
>> ---
>>
>> This applies on top of v6.9-rc5.
> 
> I chucked this into the CI on Friday and it looks to have survived the
> long weekend, so I've gone ahead and merged it into for-next/core. Short
> of any last minute failures (touch wood), this should land in 6.10.

It would be great to have some memory migration tests (including THP and HugeTLB)
thrown at this series, which should test the mapped, migration entry transitions
etc. But not sure if there are any such tests off the shelf and readily available
in the CI system.