[PATCH v3 4/5] PCI: imx6: Convert to agnostic GPIO API

[Manivannan Sadhasivam]

On Tue, May 07, 2024 at 01:44:56PM +0530, Manivannan Sadhasivam wrote:
> On Mon, May 06, 2024 at 02:10:24PM +0200, Linus Walleij wrote:
> > On Mon, Apr 29, 2024 at 12:25 PM Andy Shevchenko
> > <andriy.shevchenko at linux.intel.com> wrote:
> > 
> > > The of_gpio.h is going to be removed. In preparation of that convert
> > > the driver to the agnostic API.
> > >
> > > Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam at linaro.org>
> > > Reviewed-by: Frank Li <Frank.Li at nxp.com>
> > > Signed-off-by: Andy Shevchenko <andriy.shevchenko at linux.intel.com>
> > 
> > I think there is a bug here, the code is respecting the OF property
> > "reset-gpio-active-high"
> > but the code in drivers/gpio/gpiolib-of.h actually has a quirk for
> > this so you can just
> > delete all the active high handling and rely on 1 = asserted and 0 =
> > deasserted when
> > using GPIO descriptors.
> > 
> 
> Wow...
> 
> So this bug is present even before this series, right?
> 
> > Just delete this thing:
> > imx6_pcie->gpio_active_high = of_property_read_bool(node,
> >                                            "reset-gpio-active-high");
> 
> But this is just a bandaid IMO. The flag for the PERST# GPIO should be properly
> set in the board dts as per the board design.
> 

Hmm, no. I was confused by the property. But this quirk in gpiolib-of.c is going
to be applied while changing the GPIO state also or just during request time?

- Mani

-- 
மணிவண்ணன் சதாசிவம்