[PATCH 06/17] dt-bindings: net: mscc-miim: Add resets property

[Herve Codina]

Hi,

On Thu, 2 May 2024 15:22:09 +0200
Alexandre Belloni <alexandre.belloni at bootlin.com> wrote:

> On 02/05/2024 14:26:36+0200, Andrew Lunn wrote:
> > On Thu, May 02, 2024 at 11:31:00AM +0100, Conor Dooley wrote:  
> > > On Thu, May 02, 2024 at 11:50:43AM +0200, Herve Codina wrote:  
> > > > Hi Andrew,
> > > > 
> > > > On Tue, 30 Apr 2024 18:31:46 +0200
> > > > Andrew Lunn <andrew at lunn.ch> wrote:
> > > >   
> > > > > > We have the same construction with the pinctrl driver used in the LAN966x
> > > > > >   Documentation/devicetree/bindings/pinctrl/mscc,ocelot-pinctrl.yaml
> > > > > > 
> > > > > > The reset name is 'switch' in the pinctrl binding.
> > > > > > I can use the same description here as the one present in the pinctrl binding:
> > > > > >   description: Optional shared switch reset.
> > > > > > and keep 'switch' as reset name here (consistent with pinctrl reset name).
> > > > > > 
> > > > > > What do you think about that ?    
> > > > > 
> > > > > It would be good to document what it is shared with. So it seems to be
> > > > > the switch itself, pinctl and MDIO? Anything else?
> > > > >   
> > > > 
> > > > To be honest, I know that the GPIO controller (microchip,sparx5-sgpio) is
> > > > impacted but I don't know if anything else is impacted by this reset.
> > > > I can update the description with:
> > > >   description:
> > > >     Optional shared switch reset.
> > > >     This reset is shared with at least pinctrl, GPIO, MDIO and the switch
> > > >     itself.
> > > > 
> > > > Does it sound better ?  
> > > 
> > > $dayjob hat off, bindings hat on: If you don't know, can we get someone
> > > from Microchip (there's some and a list in CC) to figure it out?  
> > 
> > That is probably a good idea, there is potential for hard to find bugs
> > here, when a device gets an unexpected reset. Change the order things
> > probe, or an unexpected EPRODE_DEFER could be interesting.
> >   
> 
> 
> The datasheet states:
> "The VCore system comprises all the blocks attached to the VCore Shared
> Bus (SBA), including the PCIe, DDR, frame DMA, SI slave, and MIIM slave
> blocks. The device includes all the blocks attached to the Switch Core
> Register Bus (CSR) including the VRAP slave. For more information about
> the VCore System blocks, see Figure 5-1."
> 
> However, the reset driver protects the VCORE itself by setting bit 5.
> Everything else is going to be reset.
> 

Right,
I will update the reset description with:
  description:
    Optional shared switch reset.
    This reset is shared with all blocks attached to the Switch Core Register
    Bus (CSR) including VRAP slave.

Is that better ?

Best regards,
Hervé
-- 
Hervé Codina, Bootlin
Embedded Linux and Kernel engineering
https://bootlin.com