[PATCH] spi: s3c64xx: Use DMA mode from fifo size

[Jaewon Kim]

On 3/29/24 17:58, Jaewon Kim wrote:
> If the SPI data size is smaller than FIFO, it operates in PIO mode,
> and if it is larger than FIFO size, it oerates in DMA mode.
>
> If the SPI data size is equal to fifo, it operates in PIO mode and it is
> separated to 2 transfers. To prevent it, it must operate in DMA mode
> from the case where the data size and the fifo size are the same.
>
> Fixes: 1ee806718d5e ("spi: s3c64xx: support interrupt based pio mode")
> Signed-off-by: Jaewon Kim <jaewon02.kim at samsung.com>
> Reviewed-by: Sam Protsenko <semen.protsenko at linaro.org>
> ---
>   drivers/spi/spi-s3c64xx.c | 5 ++---
>   1 file changed, 2 insertions(+), 3 deletions(-)
>
> diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
> index 9fcbe040cb2f..f726d8670428 100644
> --- a/drivers/spi/spi-s3c64xx.c
> +++ b/drivers/spi/spi-s3c64xx.c
> @@ -430,7 +430,7 @@ static bool s3c64xx_spi_can_dma(struct spi_controller *host,
>   	struct s3c64xx_spi_driver_data *sdd = spi_controller_get_devdata(host);
>   
>   	if (sdd->rx_dma.ch && sdd->tx_dma.ch)
> -		return xfer->len > sdd->fifo_depth;
> +		return xfer->len >= sdd->fifo_depth;
>   
>   	return false;
>   }
> @@ -826,10 +826,9 @@ static int s3c64xx_spi_transfer_one(struct spi_controller *host,
>   			return status;
>   	}
>   
> -	if (!is_polling(sdd) && (xfer->len > fifo_len) &&
> +	if (!is_polling(sdd) && xfer->len >= fifo_len &&
>   	    sdd->rx_dma.ch && sdd->tx_dma.ch) {
>   		use_dma = 1;
> -
>   	} else if (xfer->len >= fifo_len) {
>   		tx_buf = xfer->tx_buf;
>   		rx_buf = xfer->rx_buf;


Sorry, I didn't add v2 by mistake.

This is v1 mail thread.

  - 
https://lore.kernel.org/linux-arm-kernel/CAPLW+4k4qh4ZYBufZoGbUZN0yxSE2X8bOdkEQVw1Zg9YUVpbug@mail.gmail.com/T/


Thanks

Jaewon Kim