[PATCH v1 2/2] thermal: amlogic: support A1 SoC family Thermal Sensor controller

[neil.armstrong at linaro.org]

On 28/03/2024 14:37, Dmitry Rokosov wrote:
> In comparison to other Amlogic chips, there is one key difference.
> The offset for the sec_ao base, also known as u_efuse_off, is special,
> while other aspects remain the same.
> 
> Signed-off-by: Dmitry Rokosov <ddrokosov at salutedevices.com>
> ---
>   drivers/thermal/amlogic_thermal.c | 10 ++++++++++
>   1 file changed, 10 insertions(+)
> 
> diff --git a/drivers/thermal/amlogic_thermal.c b/drivers/thermal/amlogic_thermal.c
> index 5877cde25b79..1d23afd32013 100644
> --- a/drivers/thermal/amlogic_thermal.c
> +++ b/drivers/thermal/amlogic_thermal.c
> @@ -222,6 +222,12 @@ static const struct amlogic_thermal_data amlogic_thermal_g12a_ddr_param = {
>   	.regmap_config = &amlogic_thermal_regmap_config_g12a,
>   };
>   
> +static const struct amlogic_thermal_data amlogic_thermal_a1_cpu_param = {
> +	.u_efuse_off = 0x114,
> +	.calibration_parameters = &amlogic_thermal_g12a,
> +	.regmap_config = &amlogic_thermal_regmap_config_g12a,
> +};
> +
>   static const struct of_device_id of_amlogic_thermal_match[] = {
>   	{
>   		.compatible = "amlogic,g12a-ddr-thermal",
> @@ -231,6 +237,10 @@ static const struct of_device_id of_amlogic_thermal_match[] = {
>   		.compatible = "amlogic,g12a-cpu-thermal",
>   		.data = &amlogic_thermal_g12a_cpu_param,
>   	},
> +	{
> +		.compatible = "amlogic,a1-cpu-thermal",
> +		.data = &amlogic_thermal_a1_cpu_param,
> +	},
>   	{ /* sentinel */ }
>   };
>   MODULE_DEVICE_TABLE(of, of_amlogic_thermal_match);

Reviewed-by: Neil Armstrong <neil.armstrong at linaro.org>

Keep it even it you change the compatible,

Thanks,
Neil