[PATCH v1] arm64: dts: ti: verdin-am62: use SD1 CD as GPIO

[Nishanth Menon]

On 15:49-20240312, Francesco Dolcini wrote:
> From: Francesco Dolcini <francesco.dolcini at toradex.com>
> 
> TI SDHCI IP has a hardware debounce timer of 1 second as described in

Umm... Minor clarification - the SDHCI IP is not TI's - as commit
41fd4caeb00bbd6dc55f056f3e8e956697b0760d says, this was an Arasan IP
which was integrated into TI SoCs but needs it's own driver due to some
quirkiness in the version TI picked up.

Are you OK to rephrase this as TI SDHCI 'instance' rather than 'IP'? If
yes, I can do the change locally when I commit.

> commit 7ca0f166f5b2 ("mmc: sdhci_am654: Add workaround for card detect
> debounce timer"), because of this the boot time increases of up to 1
> second.
> 
> Workaround the issue the same way that is done on
> arch/arm64/boot/dts/ti/k3-am625-beagleplay.dts, using the SD1 CD as
> GPIO.


Side benefit of this will that if you boot out of emmc and when runtime
PM disables the mmc instance, you still can detect card detect via GPIO
block, which I think is a better source of wakeup than keeping mmc
instance powered and clocked waiting for an sdcard insertion event. No
action needed, just making a side note.

> 
> Suggested-by: Nishanth Menon <nm at ti.com>
> Reported-by: João Paulo Silva Gonçalves <joao.goncalves at toradex.com>
> Closes: https://lore.kernel.org/all/0e81af80de3d55e72f79af83fa5db87f5c9938f8.camel@toradex.com/
> Signed-off-by: Francesco Dolcini <francesco.dolcini at toradex.com>
> ---
>  arch/arm64/boot/dts/ti/k3-am62-verdin.dtsi | 12 ++++++++++--
>  1 file changed, 10 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/ti/k3-am62-verdin.dtsi b/arch/arm64/boot/dts/ti/k3-am62-verdin.dtsi
> index e8d8857ad51f..a9bf2c17f95a 100644
> --- a/arch/arm64/boot/dts/ti/k3-am62-verdin.dtsi
> +++ b/arch/arm64/boot/dts/ti/k3-am62-verdin.dtsi
> @@ -457,6 +457,13 @@ AM62X_IOPAD(0x01c4, PIN_INPUT, 7) /* (B14) SPI0_D1.GPIO1_19 */ /* SODIMM 161 */
>  		>;
>  	};
>  
> +	/* Verdin SD_1_CD# as GPIO */
> +	pinctrl_sd1_cd_gpio: main-gpio1-48-default-pins {
> +		pinctrl-single,pins = <
> +			AM62X_IOPAD(0x240, PIN_INPUT_PULLUP, 7) /* (D17) MMC1_SDCD.GPIO1_48 */ /* SODIMM 84 */
> +		>;
> +	};
> +
>  	/* Verdin DSI_1_INT# (pulled-up as active-low) */
>  	pinctrl_dsi1_int: main-gpio1-49-default-pins {
>  		pinctrl-single,pins = <
> @@ -571,7 +578,6 @@ AM62X_IOPAD(0x230, PIN_INPUT,        0) /* (A22) MMC1_DAT0 */ /* SODIMM 80 */
>  			AM62X_IOPAD(0x22c, PIN_INPUT,        0) /* (B21) MMC1_DAT1 */ /* SODIMM 82 */
>  			AM62X_IOPAD(0x228, PIN_INPUT,        0) /* (C21) MMC1_DAT2 */ /* SODIMM 70 */
>  			AM62X_IOPAD(0x224, PIN_INPUT,        0) /* (D22) MMC1_DAT3 */ /* SODIMM 72 */
> -			AM62X_IOPAD(0x240, PIN_INPUT_PULLUP, 0) /* (D17) MMC1_SDCD */ /* SODIMM 84 */
>  		>;
>  	};
>  
> @@ -1441,8 +1447,10 @@ &sdhci0 {
>  /* Verdin SD_1 */
>  &sdhci1 {
>  	pinctrl-names = "default";
> -	pinctrl-0 = <&pinctrl_sdhci1>;
> +	pinctrl-0 = <&pinctrl_sdhci1>, <&pinctrl_sd1_cd_gpio>;
> +	cd-gpios = <&main_gpio1 48 GPIO_ACTIVE_LOW>;
>  	disable-wp;
> +	ti,fails-without-test-cd;
>  	vmmc-supply = <&reg_sdhc1_vmmc>;
>  	vqmmc-supply = <&reg_sdhc1_vqmmc>;
>  	status = "disabled";
> -- 
> 2.39.2
> 

-- 
Regards,
Nishanth Menon
Key (0xDDB5849D1736249D) / Fingerprint: F8A2 8693 54EB 8232 17A3  1A34 DDB5 849D 1736 249D