[PATCH] dt-bindings: reset: brcm,bcm63138-pmb: convert to yaml

[Rob Herring (Arm)]

On Tue, 11 Jun 2024 09:23:23 +0530, Kanak Shilledar wrote:
> Convert the Broadcom BCM63138 Processor Monitor Bus to newer DT
> schema. Created DT schema based on the .txt file which had `compatible`,
> `reg` and `"#reset-cells" as required properties.
> Added one line description which was missing in the original .txt file.
> Added Philipp Zabel as the maintainer (took from MAINTAINERS file).
> 
> Signed-off-by: Kanak Shilledar <kanakshilledar at gmail.com>
> ---
>  .../bindings/reset/brcm,bcm63138-pmb.txt      | 19 --------
>  .../bindings/reset/brcm,bcm63138-pmb.yaml     | 43 +++++++++++++++++++
>  2 files changed, 43 insertions(+), 19 deletions(-)
>  delete mode 100644 Documentation/devicetree/bindings/reset/brcm,bcm63138-pmb.txt
>  create mode 100644 Documentation/devicetree/bindings/reset/brcm,bcm63138-pmb.yaml
> 

My bot found errors running 'make dt_binding_check' on your patch:

yamllint warnings/errors:

dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/reset/brcm,bcm63138-pmb.example.dtb: reset-controller at 4800c0: '#power-domain-cells' is a required property
	from schema $id: http://devicetree.org/schemas/power/brcm,bcm-pmb.yaml#
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/reset/brcm,bcm63138-pmb.example.dtb: reset-controller at 4800c0: '#reset-cells' does not match any of the regexes: 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/power/brcm,bcm-pmb.yaml#

doc reference errors (make refcheckdocs):

See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20240611035329.33648-2-kanakshilledar@gmail.com

The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.

If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:

pip3 install dtschema --upgrade

Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.