[PATCH v1 0/2] arm64: meson: add support for JetHome JetHub D2

[Rob Herring (Arm)]

On Fri, 07 Jun 2024 17:50:02 +0300, Viacheslav Bocharov wrote:
> Add support for new controller.
> JetHome Jethub D2 (j200) is a home automation controller with the following
> features:
>   - DIN Rail Mounting
>   - Amlogic S905X3 (ARM Cortex-A55) quad-core
>   - micro-HDMI video out
>   - 4GB LPDDR4
>   - 32GB eMMC flash
>   - 1 x USB 2.0
>   - 1 x 10/100/1000Mbps ethernet
>   - two module slots for radio/wire interface cards
>   - 2 x gpio LEDS
>   - 1 x 1-Wire
>   - 1 x RS-485
>   - 3 x dry contact digital GPIO inputs
>   - 2 x relay GPIO outputs
>   - DC 9-36V power source with battery UPS on board option
> 
> Viacheslav Bocharov (2):
>   dt-bindings: arm: amlogic: add binding for JetHome JetHub D2
>   arm64: dts: meson-axg: add support for JetHome JetHub D2 (j200)
> 
>  .../devicetree/bindings/arm/amlogic.yaml      |   1 +
>  arch/arm64/boot/dts/amlogic/Makefile          |   1 +
>  .../amlogic/meson-sm1-jethome-jethub-j200.dts | 614 ++++++++++++++++++
>  3 files changed, 616 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dts
> 
> 
> base-commit: 32f88d65f01bf6f45476d7edbe675e44fb9e1d58
> --
> 2.45.2
> 
> 
> 


My bot found new DTB warnings on the .dts files added or changed in this
series.

Some warnings may be from an existing SoC .dtsi. Or perhaps the warnings
are fixed by another series. Ultimately, it is up to the platform
maintainer whether these warnings are acceptable or not. No need to reply
unless the platform maintainer has comments.

If you already ran DT checks and didn't see these error(s), then
make sure dt-schema is up to date:

  pip3 install dtschema --upgrade


New warnings running 'make CHECK_DTBS=y amlogic/meson-sm1-jethome-jethub-j200.dtb' for 20240607145148.2246990-1-adeep at lexina.in:

arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: /soc/bus at ff600000/bus at 60000/clock-controller at 0: failed to match any schema with compatible: ['amlogic,sm1-audio-clkc']
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller at 300: compatible: ['amlogic,sm1-tdmin', 'amlogic,axg-tdmin'] is too long
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-formatters.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller at 340: compatible: ['amlogic,sm1-tdmin', 'amlogic,axg-tdmin'] is too long
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-formatters.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller at 380: compatible: ['amlogic,sm1-tdmin', 'amlogic,axg-tdmin'] is too long
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-formatters.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller at 3c0: compatible: ['amlogic,sm1-tdmin', 'amlogic,axg-tdmin'] is too long
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-formatters.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: sys-ctrl at 0: '#address-cells', '#size-cells', 'ranges' do not match any of the regexes: 'pinctrl-[0-9]+'
	from schema $id: http://devicetree.org/schemas/soc/amlogic/amlogic,meson-gx-hhi-sysctrl.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-0: clock-names:0: 'sclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-0: clock-names:1: 'lrclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-0: clock-names:2: 'mclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-1: clock-names:0: 'sclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-1: clock-names:1: 'lrclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-1: clock-names:2: 'mclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-1: Unevaluated properties are not allowed ('clock-names' was unexpected)
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-2: clock-names:0: 'sclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-2: clock-names:1: 'lrclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: audio-controller-2: clock-names:2: 'mclk' was expected
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-tdm-iface.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: sound: Unevaluated properties are not allowed ('assigned-clock-parents', 'assigned-clock-rates', 'assigned-clocks' were unexpected)
	from schema $id: http://devicetree.org/schemas/sound/amlogic,axg-sound-card.yaml#
arch/arm64/boot/dts/amlogic/meson-sm1-jethome-jethub-j200.dtb: sound: 'anyOf' conditional failed, one must be fixed:
	'clocks' is a required property
	'#clock-cells' is a required property
	from schema $id: http://devicetree.org/schemas/clock/clock.yaml#