[net-next,PATCH v6 7/8] net: stmmac: dwmac-stm32: Mask support for PMCR configuration

[Christophe ROULLIER]

On 6/10/24 12:39, Marek Vasut wrote:
> On 6/10/24 9:14 AM, Christophe Roullier wrote:
>
> [...]
>
>>   static int stm32mp1_set_mode(struct plat_stmmacenet_data *plat_dat)
>> @@ -303,7 +307,7 @@ static int stm32mcu_set_mode(struct 
>> plat_stmmacenet_data *plat_dat)
>>       dev_dbg(dwmac->dev, "Mode %s", 
>> phy_modes(plat_dat->mac_interface));
>>         return regmap_update_bits(dwmac->regmap, reg,
>> -                 dwmac->ops->syscfg_eth_mask, val << 23);
>> +                 SYSCFG_MCU_ETH_MASK, val << 23);
>>   }
>>     static void stm32_dwmac_clk_disable(struct stm32_dwmac *dwmac, 
>> bool suspend)
>> @@ -348,8 +352,15 @@ static int stm32_dwmac_parse_data(struct 
>> stm32_dwmac *dwmac,
>>           return PTR_ERR(dwmac->regmap);
>>         err = of_property_read_u32_index(np, "st,syscon", 1, 
>> &dwmac->mode_reg);
>> -    if (err)
>> +    if (err) {
>>           dev_err(dev, "Can't get sysconfig mode offset (%d)\n", err);
>> +        return err;
>> +    }
>> +
>> +    dwmac->mode_mask = SYSCFG_MP1_ETH_MASK;
>> +    err = of_property_read_u32_index(np, "st,syscon", 2, 
>> &dwmac->mode_mask);
>> +    if (err)
>> +        dev_dbg(dev, "Warning sysconfig register mask not set\n");
>
> Isn't this an error , so dev_err() ?
No, it is only "warning" information, for MP1 the mask is not needed 
(and for backward compatibility is not planned to put mask parameter 
mandatory)
>
> Include the err variable in the error message, see the dev_err() above 
> for an example. That way the log already contains useful information 
> (the error code) that can be used to narrow down the problem.