[PATCH 2/2] arm64: dts: ti: k3-j7200-som-p0: Update mux-controller node name

[Bhavya Kapoor]

There are 2 mux-controller nodes in J7200 which are responsible for
transferring can signals to the can phy but same node names for both
the mux-controllers led to errors while setting up both mux-controllers
for can phys simultaneously.
Thus, update node names for these mux-controller.

Fixes: da23e8d1124b ("arm64: dts: ti: k3-j7200-som-p0: Add support for CAN instance 0 in main domain")
Signed-off-by: Bhavya Kapoor <b-kapoor at ti.com>
---
 arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
index 21fe194a5766..89b68325e4e2 100644
--- a/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
+++ b/arch/arm64/boot/dts/ti/k3-j7200-som-p0.dtsi
@@ -84,13 +84,13 @@ rtos_ipc_memory_region: ipc-memories at a4000000 {
 		};
 	};
 
-	mux0: mux-controller {
+	mux0: mux-controller-0 {
 		compatible = "gpio-mux";
 		#mux-state-cells = <1>;
 		mux-gpios = <&exp_som 1 GPIO_ACTIVE_HIGH>;
 	};
 
-	mux1: mux-controller {
+	mux1: mux-controller-1 {
 		compatible = "gpio-mux";
 		#mux-state-cells = <1>;
 		mux-gpios = <&exp_som 2 GPIO_ACTIVE_HIGH>;
-- 
2.34.1