[PATCH 1/3] dt-bindings: net: ti,cc1352p7: Add boot-gpio

[Simon Horman]

On Fri, Jul 19, 2024 at 03:15:10PM +0530, Ayush Singh wrote:
> boot-gpio (along with reset-gpio) is used to enable bootloader backdoor
> for flashing new firmware.
> 
> The pin and pin level to enabel bootloader backdoor is configed using

nit: enable

     Flagged by checkpatch.pl --codespell

> the following CCFG variables in cc1352p7:
> - SET_CCFG_BL_CONFIG_BL_PIN_NO
> - SET_CCFG_BL_CONFIG_BL_LEVEL
> 
> Signed-off-by: Ayush Singh <ayush at beagleboard.org>
> ---
>  Documentation/devicetree/bindings/net/ti,cc1352p7.yaml | 4 ++++
>  1 file changed, 4 insertions(+)
> 
> diff --git a/Documentation/devicetree/bindings/net/ti,cc1352p7.yaml b/Documentation/devicetree/bindings/net/ti,cc1352p7.yaml
> index 3dde10de4630..a3511bb59b05 100644
> --- a/Documentation/devicetree/bindings/net/ti,cc1352p7.yaml
> +++ b/Documentation/devicetree/bindings/net/ti,cc1352p7.yaml
> @@ -29,6 +29,9 @@ properties:
>    reset-gpios:
>      maxItems: 1
>  
> +  boot-gpios:
> +    maxItems: 1
> +
>    vdds-supply: true
>  
>  required:
> @@ -46,6 +49,7 @@ examples:
>          clocks = <&sclk_hf 0>, <&sclk_lf 25>;
>          clock-names = "sclk_hf", "sclk_lf";
>          reset-gpios = <&pio 35 GPIO_ACTIVE_LOW>;
> +        boot-gpios = <&pio 36 GPIO_ACTIVE_LOW>;
>          vdds-supply = <&vdds>;
>        };
>      };
> 
> -- 
> 2.45.2
> 
>