[PATCH v2 1/2] clk: imx93: Move IMX93_CLK_END macro to clk driver

[Krzysztof Kozlowski]

On 19/07/2024 08:08, Pengfei Li wrote:
> On Sat, Jun 29, 2024 at 10:49:49AM +0800, Pengfei Li wrote:
>> On Fri, Jun 28, 2024 at 09:38:54AM +0200, Krzysztof Kozlowski wrote:
>>> On 27/06/2024 10:24, Pengfei Li wrote:
>>>> IMX93_CLK_END was previously defined in imx93-clock.h to indicate
>>>> the number of clocks, but it is not part of the ABI, so it should
>>>> be moved to clk driver.
>>>>
>>>> Signed-off-by: Pengfei Li <pengfei.li_1 at nxp.com>
>>>> ---
>>>>
>>>> Notes:
>>>>     Change for v2:
>>>>     - Use pre-processor define to simplify code.
>>>>
>>>>  drivers/clk/imx/clk-imx93.c | 2 ++
>>>>  1 file changed, 2 insertions(+)
>>>
>>> Are you sure this builds fine? If you need to define it here, it means
>>> some part of that unit file already uses the define. If so, you include
>>> the header. If you include the header, you should see fat warning.
>>>
>>> Really, people, just build your patches...
>>>
>>> Best regards,
>>> Krzysztof
>>>
>>>
>>
>> Hi Krzysztof,
>>
>> Yes, you're right, this macro definition has indeed been used. But
>> this clk-imx93.c driver file is the only place where this macro is
>> used. So maybe it would be more appropriate to define this macro in
>> C rather than in the header file. Meanwhile, I also built my patch,
>> but no warnings were found.
>>
>> BR,
>> Pengfei Li
>>
> 
> Hi Krzysztof,
> 
> I've built my patches, but no warnings were found. This C file is the only place where this macro definition is used, so why would I see fat warning?

I could be wrong, I really thought there should be a warning of
duplicated define. But if there is none, sure, sounds good.

Best regards,
Krzysztof