[PATCH 3/3] arm64: dts: layerscape: move dwc3 usb under glue layer node

[Rob Herring]

On Wed, Jul 10, 2024 at 07:02:24PM -0400, Frank Li wrote:
> New usb glue layer driver support enable dma-coherent. So put dwc3 usb node
> under glue layer node and enable dma-coherent.
> 
> Signed-off-by: Frank Li <Frank.Li at nxp.com>
> ---
>  arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi | 43 ++++++++++++++++----------
>  1 file changed, 26 insertions(+), 17 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
> index 70b8731029c4e..24b937032480f 100644
> --- a/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
> +++ b/arch/arm64/boot/dts/freescale/fsl-ls1028a.dtsi
> @@ -615,24 +615,33 @@ gpio3: gpio at 2320000 {
>  			little-endian;
>  		};
>  
> -		usb0: usb at 3100000 {
> -			compatible = "fsl,ls1028a-dwc3", "snps,dwc3";
> -			reg = <0x0 0x3100000 0x0 0x10000>;
> -			interrupts = <GIC_SPI 80 IRQ_TYPE_LEVEL_HIGH>;
> -			snps,dis_rxdet_inp3_quirk;
> -			snps,quirk-frame-length-adjustment = <0x20>;
> -			snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
> -			status = "disabled";
> -		};
> +		usb {
> +			compatible = "fsl,ls1028a-dwc3";
> +			#address-cells = <2>;
> +			#size-cells = <2>;
> +			ranges;

No, the existing way is preferred unless you have actual glue/wrapper 
registers. Plus this breaks compatibility.

> +
> +			usb0: usb at 3100000 {
> +				compatible = "snps,dwc3";
> +				reg = <0x0 0x3100000 0x0 0x10000>;
> +				interrupts = <GIC_SPI 80 IRQ_TYPE_LEVEL_HIGH>;
> +				dma-coherent;
> +				snps,dis_rxdet_inp3_quirk;
> +				snps,quirk-frame-length-adjustment = <0x20>;
> +				snps,incr-burst-type-adjustment = <1>, <4>, <8>, <16>;
> +				status = "disabled";
> +			};