[PATCH v4] usb: dwc3: enable CCI support for AMD-xilinx DWC3 controller
Radhey Shyam Pandey
radhey.shyam.pandey at amd.com
Mon Jul 8 01:25:52 PDT 2024
The GSBUSCFG0 register bits [31:16] are used to configure the cache type
settings of the descriptor and data write/read transfers (Cacheable,
Bufferable/Posted). When CCI is enabled in the design, DWC3 core GSBUSCFG0
cache bits must be updated to support CCI enabled transfers in USB.
To program GSBUSCFG0 cache bits create a software node property
in AMD-xilinx dwc3 glue driver and pass it to dwc3 core. The core
then reads this property value and configures it in dwc3_core_init()
sequence.
Signed-off-by: Radhey Shyam Pandey <radhey.shyam.pandey at amd.com>
---
Changes for v4:
- Pass swnode GSBUSCFG0 cache property from glue driver based on
dma-coherent flag.
- Introduce function dwc3_get_software_properties().
- Rename DWC3_GSBUSCFG0_REQINFO_MASK.
- Use DWC3_GSBUSCFG0_REQINFO(n) and get rid of mask shift define.
- Rename dwc3 member gsbuscfg0_reqinfo and change it type to u32
and define 0xffffffff as unspecified.
- In comment dwc3_get_software_properties() description also mention
"non-DT (non-ABI) properties".
Changes for v3:
- In v2 review as suggested by Thinh Nguyen, switch to swnode
implementation for passing GSBUSCFG0 cache bits from AMD-xilinx
dwc3 glue driver to core driver.
Changes for v2:
- Make GSBUSCFG0 configuration specific to AMD-xilinx platform.
Taken reference from existing commit ec5eb43813a4 ("usb: dwc3: core:
add support for realtek SoCs custom's global register start address")
v1 link:
https://lore.kernel.org/all/20231013053448.11056-1-piyush.mehta@amd.com
---
drivers/usb/dwc3/core.c | 38 ++++++++++++++++++++++++++++++++++
drivers/usb/dwc3/core.h | 8 +++++++
drivers/usb/dwc3/dwc3-xilinx.c | 29 ++++++++++++++++++++++++++
3 files changed, 75 insertions(+)
diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
index cb82557678dd..fe216a6ff652 100644
--- a/drivers/usb/dwc3/core.c
+++ b/drivers/usb/dwc3/core.c
@@ -23,6 +23,7 @@
#include <linux/delay.h>
#include <linux/dma-mapping.h>
#include <linux/of.h>
+#include <linux/of_address.h>
#include <linux/of_graph.h>
#include <linux/acpi.h>
#include <linux/pinctrl/consumer.h>
@@ -599,6 +600,18 @@ static void dwc3_cache_hwparams(struct dwc3 *dwc)
parms->hwparams9 = dwc3_readl(dwc->regs, DWC3_GHWPARAMS9);
}
+static void dwc3_config_soc_bus(struct dwc3 *dwc)
+{
+ if (dwc->gsbuscfg0_reqinfo != DWC3_GSBUSCFG0_REQINFO_DEF) {
+ u32 reg;
+
+ reg = dwc3_readl(dwc->regs, DWC3_GSBUSCFG0);
+ reg &= ~DWC3_GSBUSCFG0_REQINFO(~0);
+ reg |= DWC3_GSBUSCFG0_REQINFO(dwc->gsbuscfg0_reqinfo);
+ dwc3_writel(dwc->regs, DWC3_GSBUSCFG0, reg);
+ }
+}
+
static int dwc3_core_ulpi_init(struct dwc3 *dwc)
{
int intf;
@@ -1338,6 +1351,8 @@ static int dwc3_core_init(struct dwc3 *dwc)
dwc3_set_incr_burst_type(dwc);
+ dwc3_config_soc_bus(dwc);
+
ret = dwc3_phy_power_on(dwc);
if (ret)
goto err_exit_phy;
@@ -1756,6 +1771,27 @@ static void dwc3_get_properties(struct dwc3 *dwc)
dwc->tx_fifo_resize_max_num = tx_fifo_resize_max_num;
}
+static void dwc3_get_software_properties(struct dwc3 *dwc)
+{
+ struct device *tmpdev;
+ u16 gsbuscfg0_reqinfo;
+ int ret;
+
+ dwc->gsbuscfg0_reqinfo = DWC3_GSBUSCFG0_REQINFO_DEF;
+
+ /*
+ * Iterate over all parent nodes for finding swnode properties
+ * and non-DT (non-ABI) properties.
+ */
+ for (tmpdev = dwc->dev; tmpdev; tmpdev = tmpdev->parent) {
+ ret = device_property_read_u16(tmpdev,
+ "snps,gsbuscfg0-reqinfo",
+ &gsbuscfg0_reqinfo);
+ if (!ret)
+ dwc->gsbuscfg0_reqinfo = gsbuscfg0_reqinfo;
+ }
+}
+
/* check whether the core supports IMOD */
bool dwc3_has_imod(struct dwc3 *dwc)
{
@@ -2090,6 +2126,8 @@ static int dwc3_probe(struct platform_device *pdev)
dwc3_get_properties(dwc);
+ dwc3_get_software_properties(dwc);
+
dwc->reset = devm_reset_control_array_get_optional_shared(dev);
if (IS_ERR(dwc->reset)) {
ret = PTR_ERR(dwc->reset);
diff --git a/drivers/usb/dwc3/core.h b/drivers/usb/dwc3/core.h
index 3781c736c1a1..e04640662d36 100644
--- a/drivers/usb/dwc3/core.h
+++ b/drivers/usb/dwc3/core.h
@@ -194,6 +194,10 @@
#define DWC3_GSBUSCFG0_INCRBRSTENA (1 << 0) /* undefined length enable */
#define DWC3_GSBUSCFG0_INCRBRST_MASK 0xff
+/* Global SoC Bus Configuration Register: AHB-prot/AXI-cache/OCP-ReqInfo */
+#define DWC3_GSBUSCFG0_REQINFO(n) (((n) & 0xffff) << 16)
+#define DWC3_GSBUSCFG0_REQINFO_DEF 0xffffffff
+
/* Global Debug LSP MUX Select */
#define DWC3_GDBGLSPMUX_ENDBC BIT(15) /* Host only */
#define DWC3_GDBGLSPMUX_HOSTSELECT(n) ((n) & 0x3fff)
@@ -1153,6 +1157,9 @@ struct dwc3_scratchpad_array {
* @num_ep_resized: carries the current number endpoints which have had its tx
* fifo resized.
* @debug_root: root debugfs directory for this device to put its files in.
+ * @gsbuscfg0_reqinfo: store GSBUSCFG0.DATRDREQINFO, DESRDREQINFO,
+ * DATWRREQINFO, and DESWRREQINFO value passed from
+ * glue driver.
*/
struct dwc3 {
struct work_struct drd_work;
@@ -1380,6 +1387,7 @@ struct dwc3 {
int last_fifo_depth;
int num_ep_resized;
struct dentry *debug_root;
+ u32 gsbuscfg0_reqinfo;
};
#define INCRX_BURST_MODE 0
diff --git a/drivers/usb/dwc3/dwc3-xilinx.c b/drivers/usb/dwc3/dwc3-xilinx.c
index 6095f4dee6ce..bb4d894c16e9 100644
--- a/drivers/usb/dwc3/dwc3-xilinx.c
+++ b/drivers/usb/dwc3/dwc3-xilinx.c
@@ -246,6 +246,31 @@ static const struct of_device_id dwc3_xlnx_of_match[] = {
};
MODULE_DEVICE_TABLE(of, dwc3_xlnx_of_match);
+static int dwc3_set_swnode(struct device *dev)
+{
+ struct device_node *np = dev->of_node, *dwc3_np;
+ struct property_entry props[2];
+ int prop_idx = 0, ret = 0;
+
+ dwc3_np = of_get_compatible_child(np, "snps,dwc3");
+ if (!dwc3_np) {
+ ret = -ENODEV;
+ dev_err(dev, "failed to find dwc3 core child\n");
+ return ret;
+ }
+
+ memset(props, 0, sizeof(struct property_entry) * ARRAY_SIZE(props));
+ if (of_dma_is_coherent(dwc3_np))
+ props[prop_idx++] = PROPERTY_ENTRY_U16("snps,gsbuscfg0-reqinfo",
+ 0xffff);
+ of_node_put(dwc3_np);
+
+ if (prop_idx)
+ ret = device_create_managed_software_node(dev, props, NULL);
+
+ return ret;
+}
+
static int dwc3_xlnx_probe(struct platform_device *pdev)
{
struct dwc3_xlnx *priv_data;
@@ -288,6 +313,10 @@ static int dwc3_xlnx_probe(struct platform_device *pdev)
if (ret)
goto err_clk_put;
+ ret = dwc3_set_swnode(dev);
+ if (ret)
+ goto err_clk_put;
+
ret = of_platform_populate(np, NULL, NULL, dev);
if (ret)
goto err_clk_put;
base-commit: 0b58e108042b0ed28a71cd7edf5175999955b233
--
2.34.1
More information about the linux-arm-kernel
mailing list